Garmin Bail Mounting Instructions

See the Important Safety and Product
Information guide in the GPS device
product box for product warnings and
other important information.
Garmin strongly recommends having an
®
experienced installer with the proper
knowledge of electrical systems install the
device. Incorrectly wiring the power cable
can result in damage to the vehicle or the
battery and can cause bodily injury. se bodily injury.
Always wear safety goggles, ear safety goggles, ear safety goggles, e
protection, and a dust mask when drilling, a dust mask whe a dust mask wh
cutting, or sanding.
NOTICE CE
The metal contacts on the GPS device
and the mount should be kept dry to avoid
equipment damage. Use the weather cap
on the mount at all times when the unit is
not mounted to keep the metal contacts
dry and protected.
To obtain the best performance and to
avoid damage to your boat, install the
device according to these instructions.
Read all installation instructions before
proceeding with the installation. If you
experience difficulty during the installation,
contact Garmin Product Support.
• Drill • •
• Phillips screwdriver • Phillips sc
ng an an
• 9.5 m • 9.5 mm ( • 9.5 mm
oper
• 3 bolts or 3 screws: • 3 b
ms install the ms install the
he power cable he power cable
the vehicle or the the vehicle or the
dily injury.
The swivel base must be mounted using
pan-head machine bolts or self-tapping
screws. Using screws with countersunk
heads can damage the mounting bracket.
all all
ng wi ng with th
ience diff ience difficulty d
ntact Garmin Pr ntact Garmin Product
Drill Drill
Phil
3
/ in.) wrench or socket
8
3 b
◦ #8 (4 mm) pan-head machine bolts
with nuts and washers, and a
5
5 mm ( / in.) drill bit
32
◦ #8 (4 mm) pan-head self-tapping
screws and a 1.5 mm (
bit
NOTICE
1
/ in.) drill
16