southpaw enterprises Fun Ride Deluxe 1148 Instruction Sheet

southpaw enterprises, inc.
Instruction Sheet
Fun Ride Deluxe 1148
Take time to familiarize yourself with the use and maintenance of this equipment before using. Please file
this Instruction Sheet in an accessible location: the Instruction Sheet must be read and familiar to anyone
who is using Southpaw Enterprises Equipment.
IMPORTANT: Please check equipment immediately for any damage that may have resulted during shipping.

MATERIALS LIST:

If any damage has occurred, please contact Southpaw Enterprises, Inc. immediately.
1 - Trolley Handle (2 pieces)
1 - Set of Hand Grips (2 pieces)
1 - Steel pipe
1 - Steel cable (74 ft. coil)
1 - Steel cable sling with loop at each end
1 - Turnbuckle
4 - Wheels

TOOLS NEEDED FOR ASSEMBLY:

Screwdriver (slot head)
Pliers or vise-grips
♦
Use Fun Ride only after it is properly installed by an adult.
♦
Get off Fun Ride only after it has completely stopped and drop gently to the ground.
♦
Fun Ride is designed to be used by only one rider at a time, 8 yrs. old to adult, weighing up to 225 lbs.
♦
Do not walk close to, in front of, behind, or between a moving Fun Ride or any other moving object.
♦
Not to be used without adult supervision.
♦
Always begin ride from a stable platform.
♦
Always grip handles firmly with both hands before beginning the ride.
♦
Do not attach ropes or other objects to the Fun Ride.
♦
Dress appropriately with well fitting shoes and no ponchos, scarves or other loose fitting clothing which

INSTALLATION AND ASSEMBLY INSTRUCTIONS:

1. Be sure that the structure you will install your eye bolts in will hold 600 lbs.
2. Be sure that the area between the uprights is level and at a distance of not less than 6 ft. from any structure or
obstruction.
3. Do not install the Fun Ride Deluxe over concrete, asphalt, or any other hard surface. A fall onto a hard surface
could result in serious injury to the equipment user.
4. Cable Height: For Fun Ride Deluxe to operate properly and safely it is necessary to follow the mounting
instructions carefully and observe the height recommendations. One end of the cable must be mounted at a lower
level than the other end and depending on the height of the user and the distance between the uprights, these
levels can be easily determined by consulting TABLE 1.
Measure the height of the user. If there is more than one user, and less than 6 inches difference between their heights,
then for this purpose use the height of the tallest user.
recommended that the height of the cable should be adjusted for each individual. Add 30 inches to the height of
4 - Hex head bolts with lock washers and nuts
1 - Large round head screw with lock washer and nut
1 - Small round head screw with lock washer and nut
6 - Cable clamps with lock washers, nuts and thread caps
3 - Cable thimbles
1 - Instruction Sheet
1 - Maintenance Checklist
Socket wrench
Plastic bonding glue
WARNING
Store these instructions in a safe place or
with the enclosed maintenance checklist
If the heights differ by more than 6 inches, it is
®