Advertisement
Quick Links
go warmer instructions 8.5x5 flashlight.qxp_Layout 1 10/28/20 11:16 AM Page 1
With Built In LED Flashlight
A
B
A) Go Warmer unit
B) USB Input (charges Go Warmer)
C) Flashlight Switch
D) Battery/Temperature Indicator Lights
E) USB Output (charges other devices)
F) Flashlight
G) Power Button
H) USB Charging Cable Output (large)
I) USB Charging Cable Input (small)
INSTRUCTIONS
READ CAREFULLY BEFORE USING
G
D
F
H
I
E
C
HOW TO USE:
1. With Go Warmer turned OFF, press the Power Button once to light the
Battery/Temperature Indicator Lights. If fully charged, all 3 lights will light
up. If only 1 light is lit, Go Warmer needs to be recharged.
2. To use Flashlight, locate the On/Off Switch next to the USB Output.
RECHARGING GO WARMER:
1. Use the USB Charging Cable and plug the Input (small) end into the USB
Input on Go Warmer.
2. Plug the Output (large) end into a suitable charging device or Listed/
Certified ITE Power Supply. Once fully charged, disconnect the
Charging Cable.
IMPORTANT: Use ONLY the Charging Cable provided to avoid the potential for
leaking, overheating, or explosion.
HOW TO USE HAND WARMER FUNCTION:
1. Press and hold the Power Button for 5 seconds to turn Go Warmer ON.
This is the HIGH HEAT setting and 3 indicator lights will light up red.
2. Press the Power Button once more for the MEDIUM HEAT setting
(2 indicator lights should light up red).
3. Press the Power Button once more for LOW HEAT setting (1 indicator
light should light up red).
TO TURN OFF: Press Power Button 2 times in a row until indicator lights turn off.
Advertisement
Summary of Contents for Spark GO WARMER
- Page 1 HOW TO USE HAND WARMER FUNCTION: B) USB Input (charges Go Warmer) 1. Press and hold the Power Button for 5 seconds to turn Go Warmer ON. C) Flashlight Switch This is the HIGH HEAT setting and 3 indicator lights will light up red.
- Page 2 GO WARMER USAGE TIMES AND TEMPERATURE 1. Press Power Button once to turn on charging function (indicator lights will light up blue). Make sure that the device is suitable for use with Go Warmer. It is 86F (30C) – 7hrs recommended to only use the USB cable that came with your mobile device.
Need help?
Do you have a question about the GO WARMER and is the answer not in the manual?
Questions and answers
How do I replace my lost charge g cable I found one that fits and it charged fu!ly
The manual recommends using only the USB cable that came with your mobile device. If the original cable is lost, use a compatible USB cable where the large end (USB-A) plugs into the Go Warmer's USB output and the small end (typically micro USB or USB-C, depending on your device) plugs into your mobile device.
This answer is automatically generated
My handwarmer/charger will not charge anymore. I only get the one blue light. The light will not work; the power indicator does not light up. Is it dead? Anything else that I could use it for? Should I send it back to you? Thanks for your help.
No, the Spark GO WARMER is not necessarily dead if it shows one blue light and the power indicator does not light up. One blue light indicates that the charging function is on and the battery may be low. Try fully charging the device before using it again.
This answer is automatically generated