BU-KO 8800 Original Instructions Manual
  1. Manuals
  2. Brands
  3. BU-KO Manuals
  4. Blower
  5. 8800
  6. Original instructions manual

BU-KO 8800 Original Instructions Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

BLOWER
BL-966A
ORIGINAL
INSTRUCTIONS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 8800 and is the answer not in the manual?

Questions and answers

Summary of Contents for BU-KO 8800

  • Page 1 BLOWER BL-966A ORIGINAL INSTRUCTIONS...

  • Page 2: Safety Warnings

    SAFETY WARNINGS WARNING: For your own safety, please read this manual before attempting to operate your new unit. Failure to follow instructions can result in serious personal injury. Spend a few moments to familiarize yourself with your blower before each use. If you give this tool to another person, also hand over this manual.
  • Page 3  If the machine should start making any unusual noise or vibration, immediately shut off the power source and allow the machine to stop. Take the following steps before restarting and operating the machine: a) Inspect for damage; b) Replace or repair any damaged parts; c) Check for and tighten any loose parts.
  • Page 4  DO NOT operate your unit near or around flammable liquids or gases whether in or out of doors. An explosion and/or fire may result.  DO NOT WEAR loose clothing, scarfs, neck chains, unconfined long hair, and the like. Doing so could cause injury associated with objects being drawn into the rotating parts.
  • Page 5 accessories.  Never attempt to override the interlocked feature of the guard. Residuals risks Even if you use this product in compliance with all safety requirements, potential risks of injury and damage remain. The following hazards may arise from the structure and design of this product.
  • Page 6 Risk of projection, keep bystanders away Wear ocular protection and hearing protection Guarantee sound power level Risk of fire Hot surface Risk of inhalation of exhausted gas Intended use  This blower is meant to be used for blowing leaves, dust or garden debris into a desired direction.
  • Page 7 DESCRIPTION 1. Frame carrier 10. Muffler 2. Side cover 11. Shock absorber 3. Wind cover 12. Flexible elbow 4. Spark plug cap 13. Flexible pipe 5. Gasoline engine 14. Collar for switch 6. Starter handle 15. No.1 wind pipe 7. Fuel tank cap 16.
  • Page 8 ASSEMBLY 1. Assemble No.1 wind pipe (15) to the flexible pipe (13) by turning it counter-clockwise then screwing the clamp (B) 2. Assemble flexible pipe (13) to flexible elbow (12) on blower by screwing the clamp (A1) 3. Loosen wing nut (C) completely by hand then install handle with switch (D) on the No.1 wind pipe (15) by sliding notches (E) in handle clamp;...
  • Page 9 FUELLING AND LUBRICATION Fuel Use regular grade unleaded gasoline mixed with 40:1 custom 2-cycle engine oil for best results. Use mixing ratios in the fuel mixing table below. WARNING: Never use straight gasoline in your unit. This will cause permanent engine damage and void the manufacturer’s warranty for the product.

  • Page 10: Hot Starting

     Do not use petrol which contains ethanol or methanol as it may damage the fuel lines and other engine parts.  Mix only enough fuel for your immediate needs. If fuel must be stored longer than 30 days, it should first be treated with a stabilizer or similar product.

  • Page 11: Stopping Engine

    2.move the stop switch to "I" position 3.Then push the throttle level on the open position 4.Pull recoil starter handle and engine should start. STOPPING ENGINE Release the joystick, let the machine idle. Then press the switch to stop the machine.

  • Page 12: Maintenance

    MAINTENANCE Cleaning the Air Filter Dirty air filers reduce engine power increase fuel consumption and make starting more difficult. Turn choke knob to Release the two screws (1) and pull off the filter cover (2) Remove the filter from the cover and inspect it - if it is dirty or damaged, clean the filter or fit a new one.

  • Page 13: Specifications

    Do not expose the container to direct sunlight for unnecessarily long periods. UV rays can make the container material brittle, which could result in leaks or breakage. Specifications MODELE............BU-KO-8800 Length............... 1730mm Width..............530mm Height ............... 520mm Net Weight............Max. 13kg Spark plug............CMR7H Gap (0.6~0.7) mm...

This manual is also suitable for:

Bl-966a

Table of Contents