Service Mode; Input Source - Sharp LC-26D44 Training Course

HOW TO ENTER TO SERVICE MODE
• Press the "POWER" key on the set of running TV set to force off the power.
• While holding down the "VOL (-)" and "INPUT" keys on the set at once, plug in the AC power cord to turn on the power.
The letter "K", appears on the screen.
• Next, hold down the "VOL (-)" and "P (-)" keys on the set at once. Multiple lines of character string appearing on the
screen indicate that the set is now in the adjustment Process mode. If you fail to enter the adjustment mode (the display
is the same as normal start-up), retry the procedure. (Another procedure)
• To exit of Service Mode, after the adjustment is done, unplug the AC power cord to force off the power. (When the
power is turned off with the remote controller, once unplug the AC power cord and plug it in again. In this case, wait 10
seconds before plugging.)
Main Key operation in adjustment process mode
SEES Engineering Department
Remote controller key
P (Λ / V)
VOL (+/-)
Cursor (UP / DOWN)
Cursor (LEFT / RIGHT)

INPUT SOURCE

on remote controller
OK
Main unit key Function
P (Λ / V) Moving an item (line) by one (UP/DOWN)
VOL (+/-) Changing a selected item setting (+1/-1)
———— Turning a page (PREVIOUS / NEXT)
———— Changing a selected line setting (+10/-10)
INPUT button Input source switching (toggle switching)
(TV→DTV→EXT1→EXT2→EXT3→EXT4→EXT5→EXT6
→EXT7)
———— Executing a function
Training course: D44
55

4. Service Mode