Advertisement
Figure 2
– "Filter" Position.
Water flow pattern shown with
valve handle in fully depressed
position.
Figure 3
– "Backwash" Position.
Water flow pattern shown with
valve handle in fully extended
position.
OPERATION
Valves are two position valves. Valve handle must be fully extended or fully
depressed. There is no in between, or throttling position. Connect center
port to pump.
With valve stem depressed, (Figure 2), pump water is directed to bottom
filter port. Top filter port is open to upper discharge. Lower discharge is idle.
With valve stem extended, (Figure 3), pump water is directed to top filter
port. Bottom port is open to lower discharge.
MAINTENANCE
Filter Control Valve (Slide Valve):
Turn Pump OFF Before Proceeding.
1. Inspect bi-yearly. Check for ease of operation. If handle is difficult to
move, follow steps 2 through 6 below.
2. Disassemble valve:
A. Remove three screws in index plate.
B. Remove piston assembly using a straight upward pull. Rotate assem-
bly slightly for easy removal.
3. Inspect O-Ring for nicks, cuts, cracks, etc. Replace if necessary.
4. Inspect valve seating areas for grooves, nicks, etc. Remove any corrosion
by sanding with No. 400 wet or dry emery cloth, using it wet.
NOTICE: Sand lightly so as not to destroy the seating area.
5. Lubricate O-Rings with Aqua-Lube
reassembling valve.
6. Reassemble valve:
A. Insert piston assembly into valve body.
B. Replace three screws loosely.
C. Lift the valve handle into "BACKWASH" position. This well center
the index plate with the piston shaft and valve bore.
D. Tighten three screws securely.
E. Place the piston assembly into the "FILTER" position. It should slide
easily. If not, repeat above until piston moves freely.
Winterizing For Freezing Climates:
Place valve handle in an intermediate position, between "FILTER" and
"BACKWASH" positions.
CONNECTING SLIDE V ALVE
TO FILTER SYSTEM
NOTICE: Filter ports and valve ports are furnished with union connections,
matching the connections of the filter ports. DO NOT use pipe sealants on
union collar (nut).
Use care before assembly not to damage union sealing surfaces or O-Ring.
Install union O-Rings in groove; tighten union collar hand tight.
FOR SLIP FITTINGS: Use correct solvent/cement when fitting piping or
adapters to slide valve. The valve body is ABS plastic, thus any good quality
ABS to PVC solvent can be used, such as Weld-On #793 or #710. Use P-70
(purple) primer on PVC components only. Allow a minimum of four hours
drying time prior to pressure testing or operation. If ABS adapters are glued
into valve ports in lieu of PVC fittings, use Weld-On Solvent #771, #1707
or #773.
To avoid serious personal injury or property damage, follow
cement manufacturer's instructions exactly.
FOR THREADED FITTINGS: Use Plasto-Joint Stik
may degrade plastic and create poor joints and leaks.
NOTICE: Do not overtighten.
Far Best Co., Los Angeles, CA
1
Lake Chemical Co., Chicago, IL
2
4
grease or petroleum jelly, before
1
only. Other substances
2
Advertisement
