Table of Contents
Advertisement
Sentry Air Systems Inc.
8. Before operating your unit, use the following checklist to make sure the filters are properly
installed.
9. If an adjustment to the filters is required:
4.8
Filter Cover Installation
1. Place the filter cover over the front of the filter bay enclosing the filter(s) and the unit legs.
2. Secure the cover with the two thumb-screws at the rear of the rear of the cover on each side.
Model AirHawk | © 2020 Sentry Air Systems, Inc.| 713-690-2153 | Rev 2
All filters are inserted into the chassis to the same degree; none protrudes more than
the others.
There is no visible air space between the filters.
Loosen the filter screws on top of the fan unit to allow movement of the filters.
Make sure all filters are inserted into the chassis to the same degree, presenting a
uniformly even face.
AirHawk DCH Hoods | Operation and Maintenance Manual
Page | 14
Advertisement
Table of Contents
