System Memory (Dimm Modules) - Acorp 6A815E User Manual

System Memory ( DIMM Module)
This 6A815E main board supports three 168 pin DIMM of 16 MB,
32 MB, 64 MB, 128 MB ,256MB to form a memory size between
16MB to 256MB.
The DRAM can be either 45ns,50ns,or60ns SDRAMs.
Install memory in any or all Banks in Combination:
Note:
-Supports up to 3 double sided DIMMs at 100MHz
system memory bus.
-Supports up to 2 double sided or 3 sided DIMMs at
133MHz system memory bus.
Bank
DIMM 1
( Bank 0-1 )
DIMM 2
( Bank 2-3 )
DIMM 3
( Bank 4-5 )
Note :
The DIMM Slot does not support any 5V EDO DIMM
module.
The DIMM Slot does not support any 5V SDRAM
DIMM module.
Memory speed setup is required through "Auto Con-
figuration" in BIOS chipset Setup of BIOS SOFTWARE.
If several speed memories are used, You must set Auto
Configuration to low. Example If both 50ns, 60ns are
used, Please set Auto configuration to 60ns.
It's allowed any DIMM module put in any DIMM slot.
It's allowed there are different capacity DIMM module
in all DIMM slot.
Please shut down the ATX Power when you setup the
DIMM Module.
Memory module
16MB,32MB,64MB,128MB,256MB
168 pin,3.3v SDRAM
16MB,32MB,64MB,128MB,256MB
168 pin 3.3v,SDRAM
16MB,32MB,64MB,128MB,256MB
168 pin 3.3v,SDRAM
Total System Memory(Max 512MB)
Chapter3 Installation / 13