A. & H. Meyer NETBOX Operation Manual

Operation manual „NETBOX"
Range of application:
The power strips of the type "NETBOX" are designed exclusively for use in dry rooms. They need to be installed
in furniture or mounted on furniture. The requirements for cavity wall boxes according to EN 60670 are met. For
other than the above described authorized use consult A. & H. Meyer GmbH (hereinafter referred to as AHM).
Depending on the type of „NETBOX", the product can be equipped with a drain wire for the grounding of electro-
static charges, which either can be attached during installation on site or needs to be mounted during the produc-
tion process.
The "NETBOX" is designed to a max. voltage of 250 V and current of 13 A @ 50/60Hz. Fuses may only be
exchanged for those that are equivalent in terms of load capacity and type. The maximum load of the power strip
can be found on the label and depends on the installed socket inserts and other electrical components.
The maximum load of a single item connected to the socket outlets of a NETBOX may not exceed 250 V
and a current of 5 A.
For your safety, we point out that the unused, (last) connector is to be closed with a closure that can be supplied
by us.
The power for the "NETBOX" may only be taken from an electrical supply that has a protective earth
conductor. If this or other points of this manual should be unclear, advice of a person competent in such
installation matters shall be sought to ensure that the installation is safe.
Prohibitions of application:
The power strips "NETBOX" may not be used in wet areas. Any use, where a "NETBOX" may come in touch with
splash-, drip-, spray- or jet water or may be flooded with fluids, is prohibited. The power strip should not be im-
mersed in liquids.
The "NETBOX" is not explosion-proof and may not be used in areas where an explosive environment can be
expected (areas where inflammable liquids or gases are used), nor should the power strip be used outdoors or
covered.
It is prohibited to plug the power supply cord from one "NETBOX" into another relocatable power strip or "NET-
BOX". The interconnection from "NETBOX" to "NETBOX" is only permitted by use of special connectors.
For the power supply of the "NETBOX" only connectors from manufacturers named by AHM may be used. A
mixture of products from different manufacturers is prohibited.
Repairs / warranty:
Any repair of a "NETBOX" may only be carried out by AHM or persons or firms authorized by AHM.
The power strips are sealed by destructible labels and may not be opened. A breach of the seal means the loss
of warranty and releases AHM from any responsibility.
Housing material:
The plastic parts of the "NETBOX" are made of cadmium- and halogen-free, self-extinguishing and non-dripping
materials according to UL 94 V-FR or of aluminium.
Exams:
Each power strip is subjected to a 100% final test.
A. & H. Meyer GmbH Phone: +49 5265 – 9488-0 www.ah-meyer.de 07.07.2021