3DTV STEREODRIVER X Quick Start Manual

Table of Contents

Download this manual

3DTV Corp STEREODRIVER Model X

The Model X is meant to be used with wired LCD shutter glasses and

50hz (PAL, SECAM) or 60hz (NTSC) 3D field sequential (i.e., right/left

alternating) video and tube type (CRT) TV's. For higher frequency TV

or PC see our other products.

Connect a standard RCA audio or video cord from the composite VIDEO

OUT (a yellow RCA jack) of your VCR, VCD or DVD player, STB (set top

box--i.e., cable or satellite) to the provided RCA splitter and plug the

RCA from your TV video in into the RCA splitter. Plug the splitter into

the yellow RCA jack in the back of the Model X.

If using wired glasses, plug the stereo jack of the wired LCD shutter

glasses into the mini jack on the back of the Model. Up to 6 wired

glasses can be plugged in using standard stereo headphone splitter

plugs.

First time the unit is used you need to connect the 9V battery by

removing the battery cover in the back, connecting both leads, and

replacing the cover.

Turn on the power by pressing the left button(red light) and turn off

when finished viewing 3D. When you play the 3D program the red

light on the right side should be a steady red—if it blinks you must

check all connections. If the image is 3D (one image in each eye) but

looks strange, press the right side MODE button to reverse the eyes.

If you are using wired glasses and wish to sit further from the TV, you

may use a standard stereo headphone extension cord between the

StereoDriver and the glasses or RCA extension cords to the video

source and TV.

For European User's

If there is no composite video out from your video source, but only a

Euro AV (SCART) connector then use a SCART to RCA breakout

Table of Contents

Need help?

Do you have a question about the STEREODRIVER X and is the answer not in the manual?

Page 1 3DTV Corp STEREODRIVER Model X The Model X is meant to be used with wired LCD shutter glasses and 50hz (PAL, SECAM) or 60hz (NTSC) 3D field sequential (i.e., right/left alternating) video and tube type (CRT) TV‘s. For higher frequency TV or PC see our other products.
Page 2 cable. In either case, you may connect the other RCA on the StereoDriver to the video in on your TV or connect the round RF cable from the VCR, VCD, DVD or STB to the TV. Some older equipment may not have enough power via the SCART cable, so if the light on the StereoDriver is dim or out, give it power directly from any DC adapter which makes it’s green LED go on.
Page 3 EXPOSURE TO; HEAT, LIQUIDS, DROPPING OR OTHER ABUSE. UNIT WILL BE REPAIRED OR REPLACED AT OUR DISCRETION. RETURN DEFECTIVE UNITS TO 3DTV CORP. OR YOUR DISTRIBUTOR. Adapting Your Visual System To LCD Shuttering Glasses When using shutter glasses with computer or video systems with a...
Page 4 Products may be returned for full refund minus freight charges with prior approval via email from 3DTV Corp and a tracking number MUST be provided. These warranties are in lieu of all others, express or implied and 3DTV Corporation makes no representation of the suitability, quality or performance of its products except as stated in the product literature.