Hanvon Go Go Bird User Manual

1 How to remove and charge lithium battery
a. Turn off the switch at the bottom of Go Go Bird, pull out lithium
battery from the tail of Go Go Bird, refer to figure 1.
On/off
switch
b. Plug lithium battery directly into USB charger, charger can be
connected to adaptor, computer etc., DC 5.0V power supply, refer
to figure 2.
USB Charger
c. The green signal light of the charger is on, indicating that power
is on; after inserting lithium battery, red signal light is on, indicating
that the battery is charging; red signal light is off, indicating that
the lithium battery is full.
d. After charging finished, unplug the charger from DC 5.0V power
supply and extract the lithium battery promptly.
e. Plug the full lithium battery into the battery container, tail of Go
Go Bird, pay attention to the insertion direction, refer to figure 3.
2 How to insert and remove AAA batteries of
remote control
a. Turn off the switch of the remote control, extract the battery
cover,refer to figure 4.
b. Insert two 1.5V AAA batteries correctly based on polarity
identification into battery compartment.
c. Reload battery cover, it is loaded correctly when you hear a slight
click. Remote control will automatically turn off in ten minutes
when not in use.
d. For AAA batteries that running out of power, please remove
from battery cover.
Pull out
Lithium battery
Figure 1
Lithium battery
Figure 2
Figure 3
Go Go Bird
User Manual
3 How to pair Go Go Bird with remote control
Go Go bird already matched when leaving factory, if remote
control can connect with Go Go Bird, please ignore this step. If not,
please refer to below pairing steps.
a. Turn on the switch of Go Go Bird and place the remote control
close to Go Go Bird.
b. Press the function button and turn around button (B) of the
remote control at the same time (remote control should be off),
then press the switch button of remote control, then the signal
light of remote control will be on,refer to figure 5.
c. Pay attention to the signal light of Go Go Bird, if the signal light is
flashing, indicating that the pairing matching is successful.
If fail to match, please repeat above steps.
4 How to monitor remote control
a. Pull up the rocker (upwards), Go Go Bird will speed up; move
down the rocker (downwards), Go Go Bird will slow down, refer to
figure 6.
b. Move the rocker to the left (left), Go Go Bird will turn left; move
the rocker to the right (right), Go Go Bird will turn right.
Figure 4
Signal light
Figure 5
Function button
On/off switch
Turn around
button