• Check all clamps, bolts, lids, and system accessories before testing. • Release all air in system before testing. • Tighten Sta-Rite trap lids to 30 ft. lbs. (4.1 kg-cm) torque for testing. • Water pressure for test must be less than 25 PSI (172 kPa).
Inspect valve upon receipt and file claim with carrier if parts are damaged or missing. Use the Model 14935-0100 valve only on Sta-Rite Model S200BP-2S and S240BP-2S sand filters. Do not attempt to use it on other Sta-Rite filters; the Lock Pin ports do not match.
Page 5
Far Best Co., Los Angeles, CA Lake Chemical Co., Chicago, IL Performance Curves for 2" Plastic Two Position Slide Valve, Models 14935-0100 and 14935-0300 NOTE: Curves represent total loss of both halves of valve (double pass thru valve). 10.81 (74.5) (7.6)
• Complete a warranty registration at www.staritepool.com by clicking on “Register Products” and selecting Sta-Rite Pool OR • Complete bottom portion completely and mail within 10 days of installation to Sta-Rite, Attn.: Pool Warranty Dept., 293 Wright St., Delavan , WI 53115 Warranty Registration Card ■...