Denon Professional DN-700C Update Process And Verification

Important: Before updating to the latest firmware, please make sure your DN-700C is using Firmware Version
A-2.14 or later. If it is not, please update to A-2.14 before updating to A-2.33: follow all of the steps below using
the DN700CFW.bin file, and then repeat the same procedure using the DN700CFWA.bin file.
To update the firmware on your DN-700C:
1. Unzip the contents of the downloaded .zip file to your Desktop.
2. Transfer the DN700CFWA.bin file from that .zip file to the root directory of a USB storage device.
3. Make sure your DN-700C is securely connected to a power outlet and is powered off, and then insert the
USB storage device into it.
4. Power on DN-700C.
5. DN-700C's display will show the new firmware version number. Confirm the version number is correct.
6. To continue with the update, turn the Jog Wheel on the front panel to select OK, and then press the Jog
Wheel.
During the update process, do not power off DN-700C or disconnect it from the power outlet. Doing so can
damage the unit.
To cancel the operation instead, turn the Jog Wheel on the front panel to select Cancel, and then press the
Jog Wheel.
7. Allow the update process to complete, which may take approximately 1 minute. The display may go dark
during this time. After the update is completed, DN-700C will automatically restart. Remove your USB
storage device, and delete the .bin files.
Your DN-700C now has the newest firmware.
To check the firmware version on your DN-700C:
1. With the DN-700C powered on and stopped, press the Menu key.
2. Select 06 Utility and press the Jog Wheel.
3. Select 03 Firmware Version and press the Jog Wheel. The installed firmware version will appear in the
display.
DN-700C
Latest Firmware Version: A-2.35
Release Date: July 1, 2015
Update Process and Verification