Brush; Soap Bottle - Greencut JET200L Instruction Manual

POWER ON
On first use, it is necessary to empty the air from the hose, position the power nozzle below waist level (<5 ft/1.5 m),
then connect the extension lance and set it to high pressure. waist level (<5 ft/1.5 m), then connect the extension
lance and set it to high pressure.
Do not start work until water comes up the hose and sprays out.
This may take up to 30 seconds or more, depending on the fresh water source.
ATTACHMENT OF ACCESSORIES
Several fittings have been supplied with this product and are required for use in different applications. No attempt to
use the cleaner without a lance or any accessories attached.

Soap Bottle

The soap bottle provides detergent foam for deeper cleaning of dirt. It is used in conjunction with the power nozzle
or extension lance.

Brush

The brush is used to clean cars, boats, motorbikes, etc. Used in conjunction with the power nozzle or extension lance.
MAINTENANCE
Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the engine is completely shut down before performing any maintenance
or repair. This will eliminate any potential risk.
For safety, clean the appliance every three months. Before putting the appliance into operation, check the filter and
nozzle for impurities. After the cleaning operation is complete, make sure that there is no water left in the pump and
hose.
51
EN