Advertisement
Pump the tires up to their maximum approved pressure. The lower
of the pressures specified for the rim or tire applies (Details can be
found in the enclosed tire pressure information or at www.beast-
components.de/service). Check the tire seat. The tire must contact
the rim evenly around its entire circumference. Have the tire seat
checked by a professional if in any doubt. If necessary, reduce the
tire pressure to the desired operating pressure.
RR40
RS25, RX25, RX40, RX60, RX80
GR40, GR25, XC25
XS30, XC30, TR30, ED30, DH30,
HY35
RX80
RX60
RX40, RR40, GR40
RX25, GR25, XC25, XC30, TR30, ED30,
DH30, HY30, HY35
XS30
ASSEMBLING THE CASSETTE
Choose the cassette suitable for the freewheel XD, XDR, Shimano
HG, Microspline or Campagnolo and assemble the cassette
according to the manufacturer's instructions.
BRAKE DISC
Assemble the brake disc according to the manufacturer's
instructions.
WHEEL
Ensure that the hub sits on the stop in the end of the dropout.
Observe the instructions provided by the manufacturer of the
quick-release clamp or the quick-release axle.
Check that the wheel is attached correctly before each ride.
Page 4
tubeless tape wide
22 mm
23 mm
27 mm
32 mm
37 mm
minimum valve
length
91 mm
71 mm
51 mm
36 mm
31 mm
INSTRUCTION MANUAL
MAINTENANCE AND CARE
Please always make sure that your Beast Components product is
intact before each ride. Damage can cause the component to fail,
resulting in serious injury or even death. Damaged components
should never be ridden on and should be replaced immediately. If
you are in doubt, contact us or a experienced specialist.
The following aspects should always be taken into account:
Task
Check Tubeless Tape for damages
Replace the Tubeless Tape
Check spoke tension, runout and wear of the
wheel
Check rim for damage
Clean with soft cloth and a suitable cleaner.
Attention: Do not use high pressure cleaners
or aggressive cleaning agents!
Check that the wheels are secured correctly
and Check air pressure
DISPOSAL AND ENVIRONMENTAL PROTECTION
The statutory regulations shall apply. Whenever possible, avoid
creating waste. Waste, especially carbon, lubricants, cleaners and
any other fluids must be disposed in an environmentally compatible
manner.
CONTACT
Black East GmbH
Beast Components
Hermann-Mende-Str. 5-7
01099 Dresden, Germany
+49 351 501 937 00
info@beast-components.de
www.beast-components.de
WHEELSET
Interval
every 6 months
every 12 months
every 10 opera-
ting hours
before and after
each ride
after each ride
before each ride
V2021.01
Advertisement
