Download Print this page

Installing The Battery; Storage Mode - Lake Lite LL-SML-X Quick Start Manual

Solar marine light

Advertisement

Solar Marine Light
MODEL: LL-SML-X
NOTE: BATTERY MUST BE INSTALLED & CONNECTED TO FUNCTION
INSIDE BUTTONS
Flash/Constant Switch
Mounting your Light to a Surface
1. Purchase desired mounting screws or bolts
2. Place/Space Marine Light in desired locations on surface
3. Use pencil to mark mounting holes
4. Use electric drill with small drill bit to make pilot holes
5. Use Screw Driver or Electric Screw Driver to mount unit
Recommended Screw size #10 or #12 x 1" or Longer
Mounting Surface
NOTE:
1.
LED Light inside is activated by darkness, Unit must be in a dark area before light will activate. Place in dark room to test unit.
2.
Battery must be charged in order for the LED Light to turn on. Make sure battery is connected inside and then place in sunlight to charge.
CAUTION: CONTAINS NICKEL-CADMIUM BATTERIES. BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY.
Connect Battery
Remove Screws

INSTALLING THE BATTERY

1. Remove Battery Cover from bottom of unit.
2. Connect both sides of the battery connector together
3. Internal Switch, Changes between Flashing or Constant Modes.
4. Install or check that the silicone O-Ring seal is in place and
correctly in position
5. Attach and tighten the battery cover with the provided 6-screws.
Be sure to work your way around to each screw to fully tighten.
WARNING:
LONG TERM STORAGE DIRECTIONS:
1.
Charge the Light on a Sunny Day.
2.
Before Nightfall Disconnect Battery & store battery in climate controller
area for long term storage. You may also use the magnet to disconnect
the battery for storage. Make sure the magnet will not fall out during
storage or the battery may be damaged.
the magnet in place during storage
Lake Lite Inc.
PO Box 414
LaOtto, IN 46763
Replace Screws
Use a piece of tape to secure
2-Screws/Bolts
Tools Required
For each light
Mounting Surface
Phone: 260-918-2758
Fax:
260-918-3540
E-mail sales@lakelite.com
1nm

STORAGE MODE

Insert Magnet into slot
Use a piece of tape to secure magnet in place
(the magnet will disconnect the battery for storage)
NEW:
Watch Online
Installation Video!
www.lakelite.com

Advertisement

loading