Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Specac 523-211
- Page 1 USB Temperature Controller Kit (Part No. 523-211) 2I-523-211-2...
- Page 3 USB Temperature Controller User Manual 2I-523-211-2...
-
Page 4: Table Of Contents
Software ....................11 6. I USB T DENTIFICATION OF EMPERATURE ONTROLLER FIRMWARE ................. 13 CONFIGURATION © 2019 Specac Ltd. All rights reserved. Brilliant Spectroscopy is a trademark of Specac Ltd. Other product names mentioned herein may be trademarks of their respective owners. -
Page 5: Quick Start Guide
USB Temperature Controller Quick start Guide 1. Correctly install the heated Specac accessory into the Spectrometer which is to be controlled by the USB Temperature Controller before proceeding (See the accessory’s user instruction manual for further guidance). 2. Once the accessory’s installation has been completed, connect the thermocouple and heater leads to the USB Temperature Controller connections. - Page 6 5. To operate the Specac accessory USB Temperature Controller follow the software instruction provided (See Section 5). 6. To shut down, turn off the temperature controller using the software. Allow the Specac accessory to cool, if necessary, back to room temperature before disassembly.
-
Page 7: Introduction
Waste Electrical and Electronic Equipment Directive (WEEE). If this product is in use and was purchased within the European Union, please contact your local sales agent or Specac to arrange for disposal of this equipment. -
Page 8: Safety
Indoor use only No user serviceable parts. Specac Ltd and their authorised agents only are permitted to carry out repairs. Only clean with a soft, lightly dampened cloth. Do not use harsh and/or abrasive cleaners on any Specac product. -
Page 9: Specifications
USB Temperature Controller 3. Specifications USB Temperature Controller – Thermocouple and Accessory Heater power connections USB Temperature Controller – DC supply input and USB connections Operating Temperature: 5-40°C, 0-80% Humidity non-condensing Storage conditions: -20 to +60°C Dimensions: USB Controller – 70mm (long), 80mm (wide), 32mm (high). Desktop Power Supply - 185mm (long), 84mm wide, 45mm (high). -
Page 10: Unpacking And Checklist
User Manual 4. Unpacking and Checklist On receipt of your USB Temperature Controller please check that the following have been supplied. • USB Temperature Controller (P/N - 261-058) • Desktop PSU (P/N - 267-045) • Mains power cable suitable for your country •... -
Page 11: System Requirements
USB Temperature Controller System Requirements The USB Temperature Controller software is designed to work on the following system specification: • Windows 7 SP1, 8 or 10 • Dual core Processor. • 4 Gb of memory. • 2 GHz processor. The application install size is circa 20MB or 200MB including .NET framework 4.6.2. - Page 12 User Manual Menu and settings Current temperature Set point Ramp rate On/Off Graph time scale adjustment Temperature Controller Software interface Further instructions for operation of the USB Temperature Controller are found within the software user instruction manual. This is located by clicking the “menu” button at the top left of the display screen in the application, followed by the help button near the bottom left of the display screen.
-
Page 13: Identification Of Usb Temperature Controller Firmware Configuration
USB Temperature Controller 6. Identification of USB Temperature Controller firmware configuration Different accessories from Specac have different power and heating requirements. Each USB Temperature Controller is assembled and configured to match the specific requirements of the accessory with which it is to be used. - Page 14 Tel: 215 793 4044 Tel: 03 3946 4993 Fax: 215 793 4011 Fax: 03 3946 4983 email:systems-eng@systems-eng.co.jp United Kingdom Website: www.systems-eng.co.jp Specac Ltd. - London Science and Innovation Centre, Spain Halo Business Park, Teknokroma S.Coop C. Ltda Cray Avenue, Barcelona...
- Page 15 Brilliant Spectroscopy™ www.specac.com SPECAC INC. SPECAC LTD. 414 Commerce Drive Science and Innovation Centre, Suite 175, Halo Business Park, Fort Washington, Cray Avenue, PA 19034, USA Orpington, Tel: 215 793 4044 Kent BR5 3FQ Fax: 215 793 4011 Tel:+44 (0) 1689 873134...
Need help?
Do you have a question about the 523-211 and is the answer not in the manual?
Questions and answers