Summary of Contents for Indel Marine Isotemp Basic
Page 1
Isotemp Basic, Slim/B & Slim Square Water heater Installation and operating instructions Indel Marine S.r.l. Indel Marine USA Inc. Zona Artigianale sn Gateway drive, Unit # 107 IT-61019 S. Agata Feltria (PU) Italy Pompano Beach, FL-33069 Tel. +39 0541 848 030 info@isotherm.com...
Every single water heater is individually pressure tested prior to delivery and carries a two year factory warranty in respect of defects in material and/or manufacture. Indel Marine S.r.l. accepts no responsibility or liability for damage to equipment, injury to personnel that may result from improper installation or operation of this product.
000835-3 Fig. 1 2. Mounting The Isotemp Basic, Slim & Slim Square water heaters See alternative mounting positions fi g. 2. are designed to give excellent performance when Slim Square can be standing or laying down fl at, or placed in other alternative positions as seen in fi...
Page 5
Isotemp Basic & Slim Mounting alternatives, horizontal or vertical. Fig. 2 Isotemp Basic without and with thermostat mixer valve Engine water in or out Engine water in or out ½" NPT outside thread ½" NPT outside thread FRESH WARM...
Page 6
Isotemp Basic with double coils, without and with thermostat mixer valve Engine water in or out Engine water in or out ½" NPT outside thread ½" NPT outside thread MOTOR MOTOR ENGINE ENGINE WATER WARM WATER WARM WATER OUT...
pantherRVproducts.com Slim Square without and with thermostat mixer valve FRESH WARM WATER OUT USCITA ACQUA CALDA Fresh warm water out ½" NPT outside thread ENGINE WATER ENGINE WATER ACQUA MOTORE ACQUA MOTORE Engine water in or out ½" NPT outside thread FRESH COLD WATER IN INGRESSO...
pantherRVproducts.com 4.3 Connections to engine (see connection The waste water hose must always have a free outlet. There must be no valves or skin fi ttings, fi tted to the diagram, fi g. 1): waste water hose. This hose must always have a free The water heater may be used with fresh water cooled outlet.
pantherRVproducts.com 5. Start up/test Start the engine to check the circulation of the coolant. It will be necessary to add coolant to the system to Fill the hot water tank by turning on the water compensate for the additional volume of the exchanger pressure pump and opening a hot water tap to and hoses.
pantherRVproducts.com 6:3 Replacing heater element: Warning! Be sure to turn power off fi rst! Drain the tank from water. Basic and Slim Take off the plastic cover, unscrew the two screws at the sides and push the cover downwards. Dismantle the thermostat and the overheat protector from their brackets for better access on the Slim model.