Table of Contents
Advertisement
Quick Links
DO NOT OPERATE MACHINE UNTIL YOU HAVE READ ALL SECTIONS OF THE
INSTRUCTIONS. IMPROPER USE OF THE MACHINE WILL VOID THE WARRANTY
1. Always use a defoamer when foaming occurs to prevent vacuum motor damage.
2. Always be sure to remove the cap on the pump-out fitting, and connect the dump
hose, before turning the pump(s) on.
3. Keep all filters clean. Do not operate the machine if the filters are clogged.
4. Keep machine from rain and snow, extremes in temperatures, and store in a
heated location.
5. Do not let pump run dry for extended periods of time.
FLOOD
PUMPER
120V
INFORMATION
OPERATING
INSTRUCTIONS
&
December 5, 2005
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for U.S. Products Flood Pumper
- Page 1 FLOOD PUMPER 120V INFORMATION & OPERATING INSTRUCTIONS DO NOT OPERATE MACHINE UNTIL YOU HAVE READ ALL SECTIONS OF THE INSTRUCTIONS. IMPROPER USE OF THE MACHINE WILL VOID THE WARRANTY 1. Always use a defoamer when foaming occurs to prevent vacuum motor damage. 2.
- Page 2 IMPORTANT SAFETY INSTRUCTIONS This machine is only suitable for commercial use, for example in hotels, schools, hospitals, factories, shops and offices other than normal residential housekeeping purposes. When using any electrical appliance, basic precautions should always be followed, including the following: NOTE: Read all instructions before using this machine.
- Page 3 NOTE: This machine is only suitable for commercial use, for example in hotels, schools, hospitals, factories, shops and offices other than normal residential housekeeping purposes. Record the serial number and model of your new Flood Pumper here: (and be sure to mail your warranty card)
- Page 4 Failure to do so may result in blown hoses or loose fittings; water will damage motors and switches. The two diaphram pumps on your Flood Pumper work together. When you turn the pump switch on, both pumps will run, and they will continue to run until you turn them off.
- Page 6 FLOOD PUMPER 120V PART LIST ITEM PART # DESCRIPTION ITEM PART # DESCRIPTION FP389 Recovery Tank, Complete Axle, 18-13/16” 382C Screw, Stainless Steel, 8-32" X 7/8" 2003 Wheel, 8” Latch Axle Cap, Black 2077 Hose Barb, Vacuum Inlet Bolt, 1/4-20 X 3/4”...
- Page 7 SPECIFICATIONS: One, 25 ft, 12 gauge, 3-wire with hospital grade plug POWER CORD: POWER CONSUMPTION: 13 amps, total RECOVERY CAPACITY: 12 gallon 2’ X 25’ VACUUM INTAKE HOSE: VACUUM MOTOR(s): Two 2-stage vacuum motors WATER LIFT: 90 inches CFM: OVERFLOW PROTECTION: Electronic Float / Auto ON/OFF DISCHARGE PUMPS: Two diaphram pumps...
- Page 8 FLOOD PUMPER 120V NOTES: 208-772-0573 800-257-7982 FAX: 208-772-0577 º º Coeur d’Alene, Idaho VISIT US AT: http://www.usproducts.com...
Need help?
Do you have a question about the Flood Pumper and is the answer not in the manual?
Questions and answers