Advertisement

Quick Links

J
C
F
A
U
D
I
O
A D 8
AD8
MANUAL 1.4
JCF AUDIO, LLC.
11247 CAMARILLO ST.
NORTH HOLLYWOOD, CA 91602
WWW.JCFAUDIO.COM
contact@jcfaudio.com

11 2 4 7 C a m a r i l l o S t . N . H o l l y w o o d , C A 9 1 6 0 2
w w w. j c f a u d i o . c o m

Advertisement

Table of Contents
loading

Summary of Contents for JCF Audio AD8

  • Page 1 A D 8 MANUAL 1.4 JCF AUDIO, LLC. 11247 CAMARILLO ST. NORTH HOLLYWOOD, CA 91602 WWW.JCFAUDIO.COM contact@jcfaudio.com
 11 2 4 7 C a m a r i l l o S t . N . H o l l y w o o d , C A 9 1 6 0 2 w w w.
  • Page 2: Safety Information

    Internal reference, a Word clock, a S/Pdif source (optical, or bnc), or Optionally an incoming AES/EBU stream. The AD8 has eight analog inputs that are floating and approximately 2.8k. Pin 1 of all of the female XLR’s on the unit are internally tied to circuit common. This should be kept in mind wiring systems together.
  • Page 3: Front Panel Controls

    #1/Analog input jack #5). Data - This switch controls the main function of the AD8. If D/D PEP is selected, the unit will receive 8 channels of digital input from the option port, PEP process that data and then output that data on the AES outputs.
  • Page 4: Rear Panel

    JCF Audio Rear Panel AC Power Inlet - This 3 pin IEC jack accepts 120VAC @ 50 or 60HZ. The unit is internally reconfigurable for 240VAC operation. Word Clock Input - This BNC jack accepts a standard TTL level word clock input. The in- put is 75 ohm terminated and ground referenced.
  • Page 5: Specifications

    +4dBu = -13dBFS +12dBu = -18dBFS -1dBu = -18dBFS Unit ships with attenuator approximately at mid-adjustment range (+4dBu=-18dBFS) De-emphasis is not supported anywhere in the AD8. Power Consumption: < 24 Watts J C F A u d i o A D 8...
  • Page 6: Frequency Response

    JCF Audio THD+N (400Hz and 30k BW lim) 1kHz +4dBu yielding -18dBFS : <= -77 dB (.01%) all sampling frequencies 1kHz +14dBu yielding -8dBFS : <= -74 dB (.016%) all sampling frequencies 30k BW lim 20Hz +4dBu yielding -18.3dBFS : <= -69.5 dB (.025%) all sampling frequencies 20Hz +14dBu yielding -8.3dBFS : <= -69.5 dB (.025%) all sampling frequencies...
  • Page 7: Max Dimensions

    Use of the AD8 without PEP has a lower group delay than other devices intended for the same purpose. Handling the latency with PEP engaged can be a small challenge but should be addressed.
  • Page 8 The best way of providing realtime feedback to those who need it can only be accom- plished one way. Not including latent devices like the AD8 using PEP in the loop. Careful consideration to whom needs realtime feedback and when should be consid- ered as well.
  • Page 9 AD8 with less permanent installations. 1. The AD8 is compatible with the 2 ch. optical format that is common on lots of con- sumer electronic devices, laptops, desktops, etc. The choice of which 2 channel pairs of the AD8 come out of the optical output port is selectable by jumper internally.
  • Page 10: Feature List

    • ~13dB front panel calibration range control • No active analog electronics • Cinemag analog input transformers • JCF Audio standard high isolation power supply arrangements • Very low power consumption • 2 Year Limited Warranty J C F A u d i o...
  • Page 11: Warranty

    JCF Audio 2-Year Limited Warranty JCF Audio LLC. “JCF Audio” warrants this product to be free of defects in material and assem- bly for a period of two years for parts and labor from the date of original purchase. This war- ranty is enforceable only by the original retail purchaser and cannot be transferred or assigned without express permission of JCF Audio.
  • Page 12 Without limiting the foregoing, repairs under this warranty shall be made only by a duly authorized JCF Audio service representative or by JCF Audio itself. For warranty information in other countries, please refer to the dealer or distributor.

Table of Contents