Related Manuals for ProPlex DIN Rail Opto-Splitter 1x4
Summary of Contents for ProPlex DIN Rail Opto-Splitter 1x4
- Page 1 D A T A D I S T R I B U T I O N ProPlex DIN Rail Opto-Splitter 1x4 and 1x4 RDM Quick Start Guide...
- Page 2 Setup ProPlex DIN Rail devices use a standard Phoenix MSTB screw terminal connector in various pin configurations. Please refer to the wiring diagrams below for correct hook up of your ProPlex DIN Rail product. 1. Connect the 24V DC power to the power input located in left top corner.
- Page 3 The connector should be wired as depicted in the image below. 3. Connect the optically isolated DMX signal outputs to DMX links. The connector should be wired as depicted in the image below. ProPlex Opto-Splitter DIN Quick Start Guide, v1.2 14 June 2021...
- Page 4 Connection Scheme The image below shows DMX signal “daisy-chaining” of the opto splitters via the DMX thru. ProPlex Opto-Splitter DIN Quick Start Guide, v1.2 14 June 2021...
- Page 5 Dimensions ProPlex Opto-Splitter DIN Quick Start Guide, v1.2 14 June 2021...
- Page 6 Connections ProPlex Opto-Splitter DIN Quick Start Guide, v1.2 14 June 2021...
- Page 7 YELLOW with BLINKING RED: There is RDM activity packets on the DMX link Note: ProPlex DIN Rail Opto-Splitters are a part of a lighting control signal network. Opto-Splitters are used for standard DMX signal amplification, isolation and splitting to multiple DMX outputs. Opto-Splitters ensure the safety of the equipment on either side of the Opto-Splitter.
- Page 8 Servicing the global market from offices in Los Angeles, London, New York, Toronto, and Beijing. ProPlex Opto-Splitter DIN Quick Start Guide, v1.2 14 June 2021...
Need help?
Do you have a question about the DIN Rail Opto-Splitter 1x4 and is the answer not in the manual?
Questions and answers