Summary of Contents for Sonitrol iCLASS
- Page 1 User Guide Standard and iCLASS Enhanced Keypad 19810016 REV C April 2009 Sonitrol Corporation, 211 North Union Street, Suite 350, Alexandria, VA 22314, U.S.A. Tel +1 877 SONITROL (+1 877 766-4876) Web www.sonitrol.com...
- Page 2 All rights reserved. No part of this work covered by the copyright hereon may be reproduced or used in any form or by any means graphic, electronic, or mechanical, including photocopying, recording, taping, or information storage and retrieval systems without permission of Sonitrol Corporation. Printed in the United States of America.
-
Page 3: Table Of Contents
19810016 REV C Standard and iCLASS Enhanced Keypad Table of Contents 1. Introduction ............................ 1 1.1 Your Security System ........................ 1 1.2 Overview ............................ 1 1.3 LCD Display and Keypad Buttons ..................... 1 1.3.1 Numerical Buttons ......................2 1.3.2 LED Status Indicators ....................... 2 1.3.3 SELECT Button ........................ - Page 4 Standard and iCLASS Enhanced Keypad 19810016 REV C This page is intentionally left blank. Page iv...
-
Page 5: Introduction
The Standard Keypad is the main display, programming, and user interface to the SonIP iBase and FlexiBase Systems. The iCLASS Enhanced Keypad has the same functionality as the Standard Keypad but has an integrated HID iCLASS Access Card Reader that can be configured as an Arm/Disarm reader or an access control door reader. -
Page 6: Numerical Buttons
IP iBase Standard and iCLASS Enhanced Keypad 19810016 REV C 1.3.1 Numerical Buttons The Numerical Buttons are used to enter any numerical values when prompted via the LCD menu. 1.3.2 LED Status Indicators The LED on the right side of your keypad changes colors depending on your system status. It flashes when there is an alarm no matter what color or arm state. -
Page 7: Access Control Keypad
19810016 REV C Standard and iCLASS Enhanced Keypad • Occupied Security: This allows predefined areas of your premises to be protected (i.e. exterior doors, windows, etc.) while the interior of the building remains occupied. There are two levels of occupied security available: –... -
Page 8: Disarming Your System
IP iBase Standard and iCLASS Enhanced Keypad 19810016 REV C 2.2 Disarming Your System 1. Press the ARM/DISARM Button. 2. When prompted present Card/Key fob or enter access code and press ENTER. Note: If there is only one partition, steps 3 and 4 are not required. -
Page 9: Invalid Keypad Entry
2.7 Accessing the System Menus 1. With the keypad displaying DISARMED on OCCUPIED - INSTANT or OCCUPIED - DELAYED, key in an access code and press the ENTER or for iClass keypads you can swipe your card. The system menus will then be displayed. -
Page 10: System Modes
IP iBase Standard and iCLASS Enhanced Keypad 19810016 REV C 3. System Modes 3.1 Occupied Security Levels (Delayed or Instant) Mode The Occupied security mode allows you to arm predefined areas of your premises (such as exterior doors, windows, etc.) while the interior of the building remains occupied. -
Page 11: Remote Partition
19810016 REV C Standard and iCLASS Enhanced Keypad 3.4 Remote Partition Use this selection to check or change the current status of any Partition (User permissions may limit the Partition selections available). 1. Press SELECT. Keypad Displays: READ IN BADGE OR KEY IN CODE FOR SYSTEM MENUS. -
Page 12: Event History
– Know how to cancel the alarm if the system activates. – Allow Sonitrol technicians to check and service your system regularly. Routine maintenance can – help prevent many false alarms from occurring. Notify Sonitrol immediately if you think your system is not working properly. -
Page 13: Fcc
– After you've reset the system, call Sonitrol to report the accidental activation. – If your Sonitrol system is tying up your phone line, wait several seconds and try again or use an alternate phone. – Don't leave your facility until you've spoken with Sonitrol personnel. - Page 14 19810016 REV C Standard and iCLASS Enhanced Keypad Page 10...
Need help?
Do you have a question about the iCLASS and is the answer not in the manual?
Questions and answers