Download Print this page

Martin Yale Industries ScriptStroyer UC5500 Operator's Manual

Under counter pharmacy shredder

Advertisement

Quick Links

5.0 Troubleshooting chart
Symptom
Cause
Machine will not
Red LED is flashing. The
Make sure both doors are closed. If the door is opened during a bottle cycle, the
run
bottle chute door or waste
'Start' button will need to be pushed again to complete the interrupted cycle.
bin door is open.
Yellow LED is on. Waste
Turn power switch off and empty waste bin. Turn power back on to reboot.
bin is full.
Yellow LED is flashing. Oil
Turn power switch off and fill oil tank with Intimus brand shredder oil. Turn power
tank level is low.
back on to reboot.
Yellow and Red LED's are
Unit is jammed. Run in reverse and clear jam.
flashing out of sequence
Green LED is off when
115 volt supply line is dead; check fuse or breaker panel. Resettable circuit breaker
power switch is on.
located at the rear of the machine has tripped; press in to reset (see Fig. 5 on pg 3).
All other electrical malfunc-
Contact Martin Yale customer service at (800)-225-5644.
tions
Bin full LED stays
The bin full detector locat-
WARNING: Turn the power off and unplug the power cord. Remove the waste
on when the
ed directly above waste
bin and move bin full detector back and forth to make sure it pivots freely. When
waste bin is
bin is stuck.
released, the detector should hang in a vertical position. It must be in this position for
empty
the shredder to operate (see Fig. 6 on pg 3).
Incomplete
Whole or partial vials/bot-
Remove caps from bottles before shredding. If left on, the caps will tend to slow or
shredding of vials
tles remain after cycle
prevent shredding. Press 'Start' again to complete shredding.
completes.
Unit fails to stop
Bottle pusher is jammed.
WARNING: Turn the power off and unplug the power cord. Open the bottle door
at end of bottle
The pusher motor thermal
to see if the pusher is free. CAUTION: The pusher is under significant spring
cycle
breaker will trip after
pressure. Clear out any debris which may have the pusher jammed in mid-cycle
approximately 45 seconds.
(see Fig. 7 on pg 3). IMPORTANT: the pusher can be pulled upward but not
pushed downward. The thermal breaker on the pusher motor will automatically
reset when the shredder is powered off for 30 seconds.
Unit fails to stop
Sensor in paper slot is
WARNING: Turn the power off and unplug the power cord. Locate the paper
at end of paper
dirty or blocked.
sensor at the middle of the paper slot and inspect for dirt or blockage. Clean or clear
shredding
the sensor. The unit should turn on when sensor is blocked and remain on for 5 sec-
onds after the sensor is unblocked.
Shredder makes
Shredded material is
Without feeding, alternately cycle the shredder forward and reverse for 10-15 sec-
groaning or
trapped within the shred-
onds each using the START & REVERSE buttons (the REVERSE button must be
squeaking noise
der head assembly.
held). Repeat several times to clear blades.
Auto-oiling is non-function-
Check waste bin for signs of oil. If none is present, contact Martin Yale customer
al. Unit was run in reverse
service at (800)-225-5644 for assistance in clearing air-locked oil pump and cleaning
for too long and pump lost
trapped debris from the head assembly if #1 above fails.
its prime, creating an air-
lock. Once air locked, the
pump will not self-prime
through a wet wick.
Unit stops during
Shredder was overloaded
See Operating Instructions: Bottle & Vial Shredding. If this fails, contact
shredding
and electronically shut off.
Martin Yale customer service at (800)-225-5644 for assistance.
251 Wedcor Avenue
Wabash, Indiana 46992
Phone: (260) 563-0641
Email: info@martinyale.com
M-S027919
Made in the U.S.A.
Remedy
R
Fax: (260) 563-4575
Website: www.martinyale.com
ScriptStroyer Model UC5500
Under Counter Pharmacy Shredder
Size . . . . . . . . . . . . . . . . . . . . . .17.25"W x 24"D x 33"H
Weight . . . . . . . . . . . . . . . . . .170 lbs. (192 lbs. ship wt.)
Electrical . . . . . . . . . . . . . . . . . . . .115VAC/15amp circuit
Waste bin capacity . . . . . . . . . . . . . . . .50 qt. (12.5 gal.)
Oil tank capacity . . . . . . . . . . . . . .5 quarts, 1 gallon refill
Oil type . . . . . . . . . . . . . . . . . . . . .Intimus® Shredder Oil
Oil consumption . . . . .25-30 hours shredding per gallon
Paper shred speed . . . . . . . . . . . . . . . . . . . . . .10 ft/min
Bottle shred cycle time . . . .15 sec. single - 30 sec. dual
Max. bottle size . . . . . . . . . . . . . . .2.25" dia. x 7.5" long
Max. paper size . . . . . . . . . . . . .9.13" wide x continuous
Max. paper capacity . . .approx. 10 sheets 20# copy paper
Shred-able media . . .plastic prescription vials & bottles,
Introduction
Thank you for selecting the Scriptstroyer Model UC5500 Under Counter Pharmacy Shredder. We
recommend that you familiarize yourself with the Scriptstroyer Model UC5500 by carefully reading
these instructions. Thorough understanding of the information contained within this instruction
manual will help to eliminate most operator-associated errors and ensure years of trouble-free per-
formance.
WARNING! Never connect power to the machine until you are ready to set up and operate the
shredder. During set up, operation, and maintenance keep hands, hair, loose clothing, and
jewelry away from all moving parts. Serious bodily injury could result. Service or disassem-
bly of the shredder should only be attempted with the power disconnected and locked out.
Rev. 1 3/20/09
Operator's Manual
Specifications
1.0 Nomenclature. . . . . . . . . . . . . . . . . . . . . . . . . . Page 2
2.0 Setting up the ScriptStroyer. . . . . . . . . . . . . . Page 2
Filling the oil tank
Starting up the ScriptStroyer
3.0 Operating the ScriptStroyer . . . . . . . . . . . . . . Page 2
Bottle & Vial Shredding
Paper & Label Shredding
4.0 Care and Maintenance . . . . . . . . . . . . . . . . . . Page 3
5.0 Trouble Shooting Chart . . . . . . . . . . . . . . . . . Page 4
Machine will not run
Bin full LED stays on when the waste bin is empty
Incomplete shredding of vials
Unit fails to stop at end of bottle cycle
paper, adhesive labels
Unit fails to stop at end of paper shredding
Shredder makes groaning or squeaking noise
Unit stops during shredding
Serial No.
Table of Contents

Advertisement

loading

Summary of Contents for Martin Yale Industries ScriptStroyer UC5500

  • Page 1 5.0 Troubleshooting chart ScriptStroyer Model UC5500 Symptom Cause Remedy Machine will not Red LED is flashing. The Make sure both doors are closed. If the door is opened during a bottle cycle, the bottle chute door or waste 'Start' button will need to be pushed again to complete the interrupted cycle. bin door is open.
  • Page 2 1.0 Nomenclature Paper & Label Shredding (Fig. 4) (Fig. 1) To shred paper and sheet labels, turn the power switch ON. Feed the paper into the 1. Bottle Drop Door 5. Bin Full Detector slot marked "PAPER ONLY". There is a sensor in the slot that detects the paper 2.