Table of Contents
Advertisement
your hair to loosen any knots first.
• If you are cutting/trimming for the first time, start with the styling
attachment with the longest length, to allow you to familiarize yourself with
how the device works.
• Press the On/Off button (Figure 7). The LED light turns on and the blade
begins to move.
• Starting at the top of your head, trim from the front towards the back (Figure 8).
• Holding the end of the styling attachment against your head, move it through
your hair in short strokes.
Trimming the sides of your hair
• Move the device forward from the back of your head. Make upward and
outward movements (Figure 9).
• You can also trim the side hair by moving the device in an upward and
downward motion.
TIP: The styling attachments can be moved in both directions as desired. For
best results, cut against the
direction of hair growth. If you don't achieve the desired trimming results, lift
your hair away from your scalp by back-combing.
Extendable handle
• The handle of the trimmer can be pulled out so that better results can be
achieved in hard-to-reach areas.
• Hold the handle of the device, and pull gently until it clicks into the extended
position.
NOTE: If you pull too hard on the retractable handle, it will detach from the
device.
CARE AND MAINTENANCE
• Switch off the device before cleaning.
• Take off the styling attachment.
• Turn the device to the side so that the MicroTouch® logo is visible.
• Remove the blade by pressing your thumb against its edge and pushing it
M29227_MicrotouchTitaniumTrim_Manual_20210923_CP.indd 8
M29227_MicrotouchTitaniumTrim_Manual_20210923_CP.indd 8
away from the device (Figures 13-14).
NOTE: Only one side of the blade can be removed.
• Use the brush provided to remove trimmed hair from around the main body of
the device and the blade.
• You can also use the brush to remove hair from between the teeth of the
guide comb.
• If a large amount of hair is to be removed, the blade head (removed from the
device) and the styling attachments can be rinsed under running water and
left to dry on a cloth.
• Make sure that the blade head is completely dry before replacing it.
• The handle can be cleaned with a damp cloth. Never immerse the device
in water.
• After cleaning, adjust the springs between the clips on the device until they
click back into place (Figures 15-16).
AVERTISSEMENTS
• À n'utiliser qu'à sec.
• N'utiliser que la brosse pour nettoyer la lame.
• Tenir hors de portée des enfants.
• Ne pas immerger dans l'eau ni d'autres
liquides.
• Ne pas jeter au feu.
• Le MicroTouch Titanium Trim ne doit pas être
utilisé sur les peaux sensibles ou irritées.
• Toujours examiner l'appareil avant utilisation.
8
FR
23.09.21 10:53
23.09.21 10:53
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TITANIUM TRIM and is the answer not in the manual?
Questions and answers
No manual and how do I use it
@Janyce Schlim
To use the MicroTouch Titanium Trim without a manual, follow these steps:
1. Prepare the Device:
- Hold the unit with your thumb on the soft-touch belly.
- Push the soft-touch belly upward to extend the unit from its nested position.
- Press the button on the bottom to release the handle.
- Pull the handle firmly apart from the head to separate into two pieces.
2. Install Batteries:
- Locate the teardrop-shaped end with "OPEN" embossed on it.
- Turn the end cap counterclockwise about a quarter turn and pull it out.
- Insert two AA batteries into the compartment, positive end first.
- Reattach the end cap.
3. Attach a Guide (if needed):
- Slide a styling guide over the trim head until it locks in place.
4. Use the Device:
- Extend the handle until it clicks.
- Turn the device on and use it to trim as needed.
- Avoid using it on sensitive or irritated skin.
5. After Use:
- Turn off the device.
- Remove the styling guide if used.
- Clean the blade by pushing against its edge to remove it.
Do not immerse the device in water or expose it to fire.
This answer is automatically generated
Hair trimmer can it be used on beards professionally
Can utube be used on beards
Yes, the MicroTouch Titanium Trim can be used on beards. The manual mentions trimming hair or beards, and a review also notes it was tested on a person's neck and beard.
This answer is automatically generated
Utube trimming a beard
To use the MicroTouch Titanium Trim for trimming a beard:
1. Ensure the device is disconnected before attaching or removing parts.
2. Use the longest styling attachment first to become familiar with how it works.
3. Make sure your beard is dry. Comb or brush it to remove any knots.
4. Turn on the trimmer using the power button; the LED light will turn on when the blade starts moving.
5. Trim the beard by moving the device along the hair in the desired direction.
6. If needed, remove trimmed hair using the cleaning brush included.
7. Use shorter attachments if you want a closer trim.
Trim carefully, especially on sensitive skin.
This answer is automatically generated