Table of Contents
Advertisement
Quick Links
CROP TYPE
CAL
MODE
S/DC/500-10-690 : ISSUE 3.0 : 9.11.12
MOISTURE DISPLAY
CHANGE CROP
HOLD
FOR 2 SECONDS THEN PRESS
THERE ARE 6 PRESETS A-F. THEY CAN BE RE-CONFIGURED IF
REQUIRED. (REFER TO MANUAL).
CROP
PRESET
A
WHEAT
B
BARLEY
C
OATS
D
OILSEED RAPE
E
BEANS
F
MAIZE
ADJUST MOISTURE READING
IF THE INSTRUMENT MOISTURE READING IS DIFFERENT THAN
FROM A REFERENCE MOISTURE METER :-
CAL
HOLD
UNTIL CORRECTION FACTOR (%) IS DISPLAYED
THEN PRESS
TO DECREASE % OR
FOR BEST RESULTS, ALWAYS ADJUST THE MOISTURE TO
MATCH A PRE-DETERMINED DRIED SAMPLE !
TEMPERATURE DISPLAY
PRESS TO DISPLAY TEMPERATURE
(RETURNS TO % MOISTURE DISPLAY WHEN RELEASED)
ADJUST DISPLAYED TEMPERATURE
HOLD THE TEMPERATURE BUTTON DOWN, AND AT THE SAME
TIME PRESS
TO DECREASE OR
VALUE.
MOISTURE % ALARMS
LOW MOISTURE % ALARM THRESHOLDS ARE PRESET FOR
CROPS A - F. THE DISPLAY FLASHES AND AN AUDIBLE ALARM
SOUNDS WHEN THE MOISTURE CONTENT REACHS THE
THRESHOLD.
PRESS
TO CANCEL THE LOW MOISTURE ALARM.
TO SELECT
CROP A - F
CUSTOM SETTING
TO INCREASE %.
TO INCREASE
UK690300.DOC
Advertisement
Table of Contents
Related Manuals for RDS Technology Master Driers MMM 100
Summary of Contents for RDS Technology Master Driers MMM 100
- Page 1 CROP TYPE MOISTURE DISPLAY CHANGE CROP HOLD FOR 2 SECONDS THEN PRESS TO SELECT CROP A - F THERE ARE 6 PRESETS A-F. THEY CAN BE RE-CONFIGURED IF REQUIRED. (REFER TO MANUAL). CROP PRESET CUSTOM SETTING WHEAT BARLEY OATS OILSEED RAPE BEANS MAIZE ADJUST MOISTURE READING...
- Page 2 MMM 100 Moisture Meter 2013 Software Update Guide To update 2012 instrument settings to 2013 specification (as per Software version WZ501-001 Revision 06), please proceed as follows, Reset factors to factory-default values: Press and hold the 3 inner buttons while switching the instrument on. The instrument will perform a self-test routine, then goes to the normal operating mode (M.C.
Need help?
Do you have a question about the Master Driers MMM 100 and is the answer not in the manual?
Questions and answers