Operators Manual 2 DESCRIPTION The LSU80A is a general purpose load support unit designed to act as a permanent power supply to maintain backup battery systems whilst alternative sources of power are either impractical or unavailable, such as running diesel engines during maintenance programs or removal of main power systems during maintenance.
3 INSTALLATION POSITIONING THE EQUIPMENT The LSU80A should be mounted on a level surface such as a workbench, sturdy shelf or a trolley. The unit should be sited so that at least 10cm of airspace is available all round the left and top of the unit and at least 20cm on the right hand side to allow free movement of air required for cooling.
4 OPERATION Before connecting to the load for the first time the LSU80A has to be set to the nominal voltage of the load system it is going to supply. The following steps must be followed prior to connecting to the load.
LSU80A : Load Support Unit Operators Manual 5 CALIBRATION The LSU80A has two displays which show Voltage and Current. These are electronic displays which will require regular checking for their accuracy. Intelligent Charging recommends that the calibration check procedure is followed annually.
5.2.1 Voltage adjustment With no load connected to the LSU80A switch on and press the START push button. To get the unit into calibration adjustment mode press the START push button and the OUTPUT TRIM push button both at the same time.
Intelligent Charging Limited only obligation shall be to repair or replace such products that have proved to be faulty. Intelligent Charging Limited shall not be liable for any injury, loss or damage, direct or consequential, arising out of the use, or the inability to use the product. The customer shall determine the suitability of this product for its intended use, and the customer assumes all risks and liability whatsoever in connection herewith.