Advertisement
Adjustment
Caution: Be careful when adjusting the
blade as the edge is sharp.
Depth of Cut – To adjust the depth of cut,
loosen all three blade retention screws using
the hex key supplied. Hold the blade in
place, lightly pressing down on the cutting
edge between the set screws. Use the hex
key to turn the set screws, so that the blade
is advanced or retracted as required. Be
sure to turn the set screws an equal amount;
otherwise, the taper angle will be changed.
Tighten the blade retention screws to secure
the blade. Try a couple of test holes in offcuts
to check the new setting.
Angle – To achieve the best possible fit between tenon and socket, the blade's angle may be
adjusted. Follow the same process as outlined above for adjusting depth of cut, with the exception
that the set screws must be turned an unequal amount so that the blade's angle is adjusted
as required.
Sharpening
The blade is manufactured with a straight cutting edge ground at 60°. When new, no additional
sharpening should be necessary; however, the blade will eventually require resharpening. For
use in hardwoods, lap and hone the blade at 60°; for softwoods, you may also want to burnish
a hook on the cutting edge.
Care and Maintenance
The body of the reamer is made from a steel alloy selected and heat treated for toughness.
Although it will usually withstand hard knocks without material failure, avoid dropping the
reamer on a hard surface such as a concrete floor.
Store in a dry place. The reamer can rust if exposed to moisture or humid conditions. As with
any iron or steel tool, an occasional application of silicone-free paste wax will prevent rust.
Accessory
05J61.02
Replacement Blade
Veritas Tools Inc. Ottawa ON K2H 1C2 Canada veritastools.com
© Veritas Tools Inc. 2018
Figure 3: Adjusting the depth of cut.
444 INS-278_D
Advertisement
