Advertisement
Quick Links
Advertisement
Summary of Contents for Omron Microscan NL-220
- Page 1 NL-220/NL-220F Communications Quick Start Guide 83-200045 Rev A...
- Page 2 The NL220 (F) controllers communicate via an on-board web server as a user interface to set the required parameters to operate current Omron Microscan lighting. The instructions below show you how to acquire the network address of your NL-220 and start utilizing your controller. There are two means to accomplish acquiring the network addr.
- Page 3 Acquire Network Address DHCP DHCP (dynamic host configuration protocol) The NL220 acquires its IP addr, subnet mask and gateway addr from a DHCP server. The PC on the network that you will communicate with your NL220 will have its Internet Protocol TCP/IP) properties set to “Obtain an IP address automatically”.
-
Page 4: Configuration Program
Acquire Network Address DHCP - Configuration Program CONFIGURATION PROGRAM Install and run Omron Microscan NL Configuration program. NOTE: Upon executing this program, you may be prompted to select the network adaptor to utilize. This case will arise if you are tied to multiple network adaptors. Select your adaptor and proceed. - Page 5 Acquire Network Address DHCP - Configuration Program Ethernet Connection Click Search NL220, NL220F Communications Quick Start Guide...
- Page 6 Acquire Network Address DHCP - Configuration Program Ethernet Connection Click Search After clicking Search, click on The address will appear in the IP Address area as above. Now, open your PC Internet browser and type the network address of the NL220 at the URL address bar and hit enter.
-
Page 7: Pushbutton Method
Acquire Network Address DHCP - Pushbutton Method PUSHBUTTON METHOD The names of the pushbuttons are “SEL”, “UP Arrow” and “DOWN Arrow”. Action (Push Button on NL220) Reaction (7 segment display readout) Press “SEL” “CH1” Press “Up Arrow” “CH2” Press “Up Arrow” again “EtH Press “SEL”... - Page 8 Acquire Network Address DHCP - Pushbutton Method The NL220 is now in “F1P” mode. Fixed internet address mode. In order to reset back to DHCP mode: Press “SEL” “CH1” Press “Up Arrow” “CH2” Press “Up Arrow” again “EtH Press “SEL” “F1P”...
- Page 9 Acquire Network Address FIP FIP (fixed internet address) You may desire to communicate with your NL220 on a private network (using a PC dedicated to only communicating with your NL220(s)). A crossover network cable is needed. (depending on the age of your PC, you may not require a crossover cable.
- Page 10 Acquire Network Address FIP You must change the IP address in your NL220. The action is similar to reading the allocated address. We will use this example: 192.168.1.201 Action (Push Button on NL220) Reaction (7 segment display readout) Press “SEL” “CH1”...
Need help?
Do you have a question about the NL-220 and is the answer not in the manual?
Questions and answers