Subscribe to Our Youtube Channel
Related Manuals for DimSport YOUTUNE
Summary of Contents for DimSport YOUTUNE
- Page 1 Installation and use Controller for Rapid Bike Evo and Rapid Bike Racing modules Issued by: PM approved by DG Rev.01 date 03/09/18 pag. 1/10...
-
Page 2: Main Features
Description YOUTUNE is a calibration device showing data relative to the main functions performed by Rapid Bike EVO and RACING module with the purpose to interact in real time and modify the related parameters within a range of pre-set values, including the possibility to enable/disable them. -
Page 3: Installation
WARNING The device flashes continuously in case a communication problem is detected: 1. Update the Rapid Bike module’s firmware as mentioned previously. 2. Youtune harness may have been damaged during installation. Check it and repair. Ten LEDs on a curved... - Page 4 RPM => Displays various information TPS: Throttle Position Sensor measured in % Feature available for both Rapid Bike Evo LED → TPS and Racing modules Display → RPM Push LED → AFR Display → RPM AFR: Air / Fuel Ratio Push LED →...
- Page 5 RPM => RPM/Speed control LEDs flash alternately Feature available for both Rapid Bike Evo and Racing modules Press button (-) for 2 seconds to activate an rpm limiter at the To disable it, push actual rpm value MODE button, or press In order to enhance the button (-) for 2 seconds, riding comfort, we suggest...
- Page 6 AFR => My Tuning Bike installed => displays/modifies AFR target. Display shows the AFR measured by the My Tuning Bike’s wideband O2 sensor, LEDs indicate AFR’s trend AFR target can be modified only with My Tuning Bike connected Adjustments range: ±10 (1 = 0,1 AFR) QS =>...
- Page 7 EB => Engine braking control Feature available for both Rapid Bike Evo LEDs indicate RPM and Racing modules Display indicates the adjustment over the software’s Press (-) to reduce setting (±20 points) 0 means the feature is active the engine braking, with the software’s setting (+) to increase it Press button (-) after -19 will...
- Page 8 Display confirms Step 2: engine accelerates while power output is controlled avoiding rear tyre spin Release the clutch gradually Once Step 2 is completed, Youtune goes back to default RPM visualization Issued by: PM approved by DG Rev.01 date 03/09/18...
-
Page 9: General Information
For each feature adjustable with Youtune, Rapid Bike Master software shows the software's settings, the actual value of Youtune controller and the resulting value from the sum of the two. For further information regarding Rapid Bike modules' features mentioned in this manual, please refer to the Rapid Bike Master software's manual. - Page 10 Issued by: PM approved by DG Rev.01 date 03/09/18 pag. 10/10...
Need help?
Do you have a question about the YOUTUNE and is the answer not in the manual?
Questions and answers