jobmate 54-2815-2 Owner's Instructions

Owner's Instructions
6V Cordless Screwdriver
54-2815-2
! WARNING:
Read all instructions and warnings
before operating this tool.
SAVE THESE INSTRUCTIONS! READ ALL INSTRUCTIONS!
1-year Warranty
This JobMate product carries a one (1) year warranty
against defects in workmanship and materials. Trileaf
Distribution agrees to replace the defective product free of
charge with the same model or one of equal value or
specification, within the stated warranty period, when
returned by the original purchaser with proof of purchase.
This product is not guaranteed against wear or breakage
due to misuse and/or abuse.
This product is not guaranteed if used for industrial or
commercial purposes.
TOLL FREE HELPLINE: 1-866-JOBMATE
!
WARNING:
To avoid possible serious injury:
Always keep your hand away from the rotating screwdriver
bit. The bit could slip off the screw and injure your hand.
Never wear gloves. A glove could get caught in the rotating bit
or screw and injure your hand.
Never touch the ON/OFF switch while changing screwdriver
bits.
INSERT BATTERIES (NOT INCLUDED)
Install four "AA" Alkaline batteries as follows:
1. Squeeze latches (1) on each side of the battery box (2) and
pull the battery container out of the tool handle (3)
(see Fig. 1).
2. Insert 4 batteries in the battery box.
NOTE: Make sure the batteries are positioned exactly as
indicated by the illustrations in the battery box.
3. Slide the battery box back into the tool handle.
NOTE: Make sure the slots (4) in the battery box match up
with the keys in the tool handle. The battery box will only fit
one way.
Fig. 1
Imported by Trileaf Distribution Trifeuil Toronto, Canada M4S 2B8
Rev 1 08/02/06
Screwdriver bit Screwdriver bit
#1 & #2 Square #1 & #2 Philips
SETTING POWER/MANUAL CONTROL
To drive or remove screws using the battery power, rotate the
power/manual control (1) so the indicator (2) is set on power (3)
(see Fig. 2). To lock the screwdriver in manual mode for final
tightening or loosening screws, rotate the power/manual control
so the indicator is set on manual (4).
Fig. 2
INSERTING SCREWDRIVER BITS
Insert one of the supplied screwdriver bits (1) into the metal
chuck (2) (see Fig. 3).
NOTE: The screwdriver bits will be held in the chuck
magnetically.
Fig. 3
DRIVING & REMOVING SCREWS
1. Insert appropriate screwdriver bit as noted above.
2. Place the tip of the screwdriver bit (1) fully into the screw
head recess (see Fig. 4).
NOTES:
a) Press the ON/OFF button from the RIGHT side (2) to drive
screws. Press the ON/OFF button from the LEFT side (3) to
remove screws.
b) To stop the screwdriver bit from rotating, release the
ON/OFF switch button. It will move to the middle (OFF)
position
3. Push the screwdriver to firmly hold the screwdriver bit in the
screw head while driving or removing screws.
NOTE: Hold the screwdriver with one or two hands,
whichever is more comfortable.
Screwdriver bit
® 1
/ & ¼ Slot
8
Fig. 4