Philips Nike PSA260 Frequently Asked Questions Manual page 4

How do I hook up the Nike PSA260 player with my computer?
For Windows98 users
, make sure that you have already installed the software in your PC. The software and the driver
installation must be completed before making any connection or else the PSA player will not be recognized by your PC.
For WindowsME/2000/XP users
the USB port on your PC. An application will launch and the unit will be recognized as a USB Mass Storage Class device
and listed as Removable drive in Windows Explorer automatically, therefore no separate installation of driver is
required.
1. Turn on your computer
(Always turn on the computer before hooking up the player)
2. Connect the supplied USB cable to your computer's USB port (with the bigger end of the cable connected to the
computer).
3. Open the USB cover at the bottom of the player; connect the small end of the USB cable to USB connector.
4. An icon of the device connecting to the computer should show on display of the PSA260.
(Back to Top)
How do I install the speed and distance monitor (SDM)?
1. Use a coin to twist clockwise to open the speed monitor battery door. Remove the plastic insert to Insert an AAA
battery with "+" polarity end first. Replace the battery door, pressing fully in and twist counter-clockwise to secure
the closing.
2. Unhook the rubber strap and detach the clip. Loosen shoelaces and slide monitor clip under laces. Securely the
monitor to your running shoe. The monitor should rest just below where laces tie and be secure enough to stay in
place the closing of the clip must point towards the sole during running.
3. Press and hold the
the monitor. Your monitor will blink. The monitor is now ready to record your running activities
4. After running is completed, press and hold the RUN key for 1 second to stop logging, then press and hold SDM
button for 2 seconds to power off your monitor after use.
ATTENTION: Anyone beginning an exercise regimen for the first time (especially users of
pacemakers or other implanted devices) should consult a physician or health professional before
using the MP3RUN PSA player)
(Back to Top)
How do I switch my Nike PSA260 player on /off?
For first time use, make sure that you have the player charged for at least 4 hours with the supplied charger connected
to the USB port on the edge of the player and the main power supply. Disconnect the player from the charger. Press and
hold the button for 2 seconds; the display will come on automatically. To switch off the unit, press and hold the
button again for 2 seconds at any stage.
(Back to Top)
, as the PSA260 player supports USB Mass Storage Class, simply hook up the player to
key for 2 seconds to power on your player. Press SDM button for 2 seconds to power on