Advertisement
Quick Links
Advertisement
Summary of Contents for Zig Zag KMC3500
- Page 1 Zig-Zag Message Center Assembly Instructions Model# KMC3500...
- Page 2 Before assembly, please make sure all components are included. (2) Large Vertical (1) Middle Large Vertical Double Message Double Message Center Center AMC-A0004 AMC-A0008 (2) Large Vertical (1) Middle Large Vertical Roof Roof AMC-A0009 AMC-A0010 (2) Inground Post (2) Inground Outer Assembly Post AMC-A0006...
-
Page 3: Required Tools
Before assembly, please make sure all hardware is included. (6) - 1/4" Flat Washer (6) - 1/4"-20 x 3.50" Lag Screw (16) - 3/8" Flat Washer (4) - 3/8" x 5.00" Hex Head Bolt (12) - 3/8" x 6.50" Hex Head Bolt Required Tools -Power drill/Screw gun -7/16"... - Page 4 30" - 36". Make each hole approximately 10" wide in diameter. These holes will be used to construct middle section of the Zig Zag Message Center. Refer to post hole layout at end of instructions for more detail.
- Page 5 Components required for Step 2: (1)Inground Outer Post (1)Large Vertical Double Message Center Hardware required for Step 2: (2) 3/8" x 5.00" Hex Head Bolt (2) 3/8" Flat Washer Step 2: Lay out the required components as shown in the illustration. Attach the Inground Outer Post to the Large Vertical Double Message Center as shown using the indicated hardware.
- Page 6 30" - 36". Make each hole approximately 10" wide in diameter. These holes will be used to construct end section of the Zig Zag Message Center. Refer to hole layout at end of instructions for more detail.
- Page 7 Attach Large Vertical Roof to Large Vertical Double Message Center as shown. Secure Roof using the supplied 1/4"-20 x 3.50" Lag Screw. Note that the other Roof hole is located on opposite side of message center. Repeat step for each section of the Zig Zag Message Center. LARGE VERTICAL ROOF...
- Page 8 Post Hole Layout DIG HOLES 10" WIDE STEP 2 AT A DEPTH OF 30" - 36.00" STEP 1 41.000 STEP 2 REFERENCE MEASUREMENT...