Wbe 4140 - Bosch WBE 4140 Repair Instructions

en 26 | WBE 4140 | WBE 4140
2.

WBE 4140

12
13
14
Fig. 1: WBE 4140
Item Designation
1 TFT monitor
2 Wheel guard
3 Gauge arm (accessory)
4 Vernier caliper (electronic)
5 Cone of drive shaft
6 Pedal
7 Control panel
8 Tray
9 Mains socket
10 On/off switch
11 Centering flange
12 Quick-action clamping nut
13 Manual vernier caliper
14 Measuring compasses
15 Clamping tool holders
|
1 695 655 779 2010-11-9
11
7
10
9
Function/purpose
Software display (measured values and operating instructions)
R Protection of operator against flying particles (e. g. dirt, water).
R Starting and stopping measurement, refer to Section 8.3.3.
Determination of rim width
R Recording of rim distance and rim diameter.
R Determination of positions for attachment of adhesive weights.
Flange mounting.
Locking of shaft / wheel.
Operation of WBE 4140, refer to Section 7.3
For storing balance weights and accessories.
Connection for power cord.
Switching WBE 4140 on and off.
Wheel attachment.
Centering and attachment of wheel on cone.
Can be used as substitute if the electronic vernier caliper is defective.
Can be used as substitute if the rim width and rim diameter cannot be recorded
electronically.
For storing accessories.
1
4
8
15
6
2
3
5
Robert Bosch GmbH