Subscribe to Our Youtube Channel
Summary of Contents for RGB Technology 102-02-07
- Page 1 TECHNICAL AND OPERATIONAL DOCUMENTATION IR remote control for the devices of ZA and ZB series Product code: 102-02-07 *Explanatory figure...
-
Page 2: Table Of Contents
IR remote control dimensions ........................3 Configuration of the devices of ZA and ZB series using the IR remote control ........4 Pairing of the IR remote control with the RGB Technology devices ............4 Removing the programmed remote controls .................... 4 Manual setting of the time and date ...................... -
Page 3: Manufacturer
1 Manufacturer RGB Technology Sp. z o. o. Karola Mytnika 28 75-129 Koszalin POLAND 2 Specifications IR remote control for the devices of ZA / ZB series Dimensions [mm]: 86.2 x 40 x 8.3 Range Remote control power supply CR2025 battery... -
Page 4: Configuration Of The Devices Of Za And Zb Series Using The Ir Remote Control
5.1 Pairing of the IR remote control with the RGB Technology devices For the RGB Technology devices with the IR control module, after connecting them to the power supply, the procedure of learning addresses is active for 60 seconds, and, during this time, the user can add the IR remote controls. - Page 5 DTR_102-02-07-001_EN_f...
-
Page 6: Manual Setting Of The Time And Date
5.3 Manual setting of the time and date To set the clock (enter the current date and time), you should: 1) Call the configuration menu by pressing the MENU key. 2) Select the „F1” function using the ↑ and ↓ keys and confirm it with the → key. →. 3) Using the ↑... -
Page 7: Configuration Of The Time Synchronisation, Time Zones, Taking Into Account The Daylight Saving Time And The Master Mode
5.6 Configuration of the time synchronisation, time zones, taking into account the daylight saving time and the Master Mode To configure the time synchronization, time zone , taking into account the daylight saving time or to activate the Master Mode , you should: 1) Call the configuration menu by pressing the MENU key. -
Page 8: Configuration Of The Alarms
To set the display brightness manually, you should: 1) Call the configuration menu by pressing the MENU key. 2) Select the F5 function using the ↑ and ↓ keys and confirm it with the → key. 3) Using the ↑ and ↓ keys, select your preferred brightness and confirm it with the → key. br 1 Minimum brightness …... -
Page 9: Configuration Of The Display Font
5.10 Configuration of the display font To change the display font shape, you should: 1) Call the configuration menu by pressing the MENU key. 2) Select the F8 function using the ↑ and ↓ keys and confirm it with the → key. 3) Using the ↑... -
Page 10: Hardware Restoring Of The Clock Factory Settings
5.15 Hardware restoring of the clock factory settings To do the hardware restoring of the clock factory settings, you should: 1) Disconnect the device from the power supply. 2) Make sure that a cable is not connected to the GPS connector (disconnect if it happens). 3) Connect the GPS pin to the GND pin in the connector.
Need help?
Do you have a question about the 102-02-07 and is the answer not in the manual?
Questions and answers