Toro 139-5636 Installation Instructions Manual page 5

Figure 4
1. Engine bolt (previously
removed)
2. Engine-mounting-bracket
bolt (previously removed)
3. Washer (3/8 x 1-1/8 inch)
4. Mount the engine onto the engine-mounting
bracket using the previously-removed bolts and
nuts (Figure 4).
Note:
To make installing the engine to the
frame easier, tighten the bolts 90% of the way.
5. Install the clutch cable to the clutch plate
5).
g312414
4. Engine nut (previously
removed)
5. Rear left engine bolt
(Figure
1. Clutch plate
2. Clutch cable
6. Install the spring end of the clutch cable to the
clutch lever (Figure
7. Install the throttle cable to the machine, refer to
the machine Service Manual
•
Use the throttle cable that is 172.2 cm
(67-13/16 inches) long for a Model 04056
traction unit; refer to
1. Throttle cable
•
Use the throttle cable that is 158.3 cm
(62-3/8 inches) long for all models, but not for
a Model 04056 traction unit; refer to
1. Throttle cable
Note:
Observe the throttle-cable routing as
shown in Figure
side of the engine and between the air-cleaner
cover and fuel tank.
5
Figure 5
3. Clutch-cable spring end
4. Clutch lever
5).
(Figure 8).
Figure 6.
Figure 6
2. 172.2 cm (67-13/16
inches)
Figure 7
2. 158.3 cm (62-3/8 inches)
8. Route the cable to the left
g312403
g327886
Figure 7.
g327886