Titan MLS10 Operator's Manual page 6

Before using the log splitter, review the instructions below and all safety information. Failure to
follow these instructions may result in property damage or injury to the operator or bystanders.
SPLITTING OPERATION / ADDITIONAL SAFETY INSTRUCTIONS
1.
When loading or positioning a log always use the bark side, never the ends. Never place your
hands or body parts between the log and the splitter.
2.
Never load or unload logs while the ram is moving.
3.
Do not pile logs to be split in a place where you need to reach across the splitter to load them.
4.
Log ends need to be cut square, so they do not slide out while splitting and cause a safety
hazard or excessive force to the log splitter components. Use a chainsaw (not included) to cut
the logs ends square before attempting to split them.
5.
Never attempt to split more than one log at a time. A piece of a log can unexpectedly be thrown
from the machine, causing personal injury.
6.
Do not use if there is any indication of damage to the hydraulic cylinder.
7.
Do not use the splitter to split logs across the grain. Doing so will damage the log splitter and
could cause log pieces to be thrown, injuring the operator or bystanders.
Accidents occur when there is more than one person involved in loading and operating the log
splitter. Only one person should operate the splitter, if a second person is assisting in loading the
splitter, NEVER allow an assistant to hold the log in place while the operator is using the working the
handles.
USING YOUR 10TON LOG SPLITTER
1. Grip one handle in each hand and pump the handles back-and-forth stroke motion.
This action will force the log against the wedge.
2. Remove the split pieces
3. Turn the hand wheel counterclockwise, no more than one full turn to retract the ram.
4. Turn the hand wheel clockwise unit it is snug.
5. When finished splitting turn the hand wheel counterclockwise one turn to relieve the pressure.
OPERATION INSTRUCTIONS
WARNING
WARNING
6