Related Manuals for MTS Sensors Temposonics G Series
Summary of Contents for MTS Sensors Temposonics G Series
- Page 1 Temposonics ® Absolute, Non-Contact Position Sensors G-Series Handheld Programmer for analog sensors Instruction Manual Part No. 253 853 (replacement for part no. 253 294)
- Page 2 (Green ON, Red OFF). No power to sensor Self-diagnostic error Flashing IR programming mode Normal sensor function Magnet not detected Flashing Missing (external) interrogation Flashing Serial programming mode Flashing Magnet signal weak Flashing Flashing Power out of range (high or low) MTS Sensors...
- Page 3 Setpoint 1 and/or Setpoint 2. Perform the steps 2 through 5 to save the new settings. Repeat the whole procedure, as needed, to get additional distance between setpoints. MTS Sensors...
- Page 4 © MTS Temposonics ® BA G-Series Handheld Programmer 0902010e - Alterations reserved Deutschland Japan MTS Sensor Technologie MTS Systems Corporation MTS Sensors Technology Corp. GmbH & Co. KG Sensors Division 737 Aihara-cho, Auf dem Schüffel 9 3001 Sheldon Drive Machida-shi 58513 Lüdenscheid, Germany...
Need help?
Do you have a question about the Temposonics G Series and is the answer not in the manual?
Questions and answers