Subscribe to Our Youtube Channel
Summary of Contents for Skutt KILNMASTER AUTOMATIC KILNS
- Page 3 plugging in Hold Enter Enter Cone Fire Cone number degrees F/C Enter Enter Slow Medium Fast Enter 9999 00.00 00.00 Enter...
- Page 4 hold time Ramp/Hold. Enter USEr Number Repeat Enter ALAr number of segments Enter Enter heating rate Enter - - - - first temperature to reach Enter Start USEr...
- Page 9 e l e m ent .
- Page 13 Enter Cone Fire Enter Medium Enter Enter Hold Start...
- Page 17 STOP Enter Review...
- Page 20 Enter • Review • View Stop Review...
- Page 23 HOLd ConE...
- Page 24 CPLt Cone Fire Enter -ON- Enter deLA Enter Review ALAr Delay Alarm Review - - - - Start...
- Page 25 Stop...
- Page 26 ALAr - - - - SEGS rA 1-8 F 1-8 HLd 1-8 USEr CPLt -ON- deLA...
- Page 27 Enter Ramp/Hold Enter Enter Ramp/Hold 5 7 0 1 to 6 Enter Enter 1 6 9 4 Stop Enter Enter 1 0 8 Review Enter 1 9 4 4 Enter Start Enter 9999 Enter View Enter Delay Enter Alarm Review Start...
- Page 28 Hold Temperature Rate 6.00 1100 2.00 2100 2345...
- Page 29 Temperature Rate Hold Porcelain Fire This Cone 5 firing of appproximately10 hours is just one example of a porcelain fire with rates calculated to produce a 1000 desirable temperature profile. 1150 1915 2165 Hold Temperature 1250 2100 2330 3.00 2050...
- Page 30 F or Alarm Enter 0 - 9 9 9 9 Enter Enter Delay 0 - 9 9 9 9 Enter...
- Page 31 Cone Table 0 2 2 - 1 0 Review View...
- Page 32 Start Firing From the flashing temperature, press Start to begin a firing. The controller will display On while it does a self-check. The amount of time in a delay start is then displayed and is counted down until zero delay is remaining, at which time the firing starts. During firing, the kiln temperature is displayed.
- Page 33 Cone Fire Ramp/Hold Enter Enter 0000 Enter Start Cone Fire. Enter Start Enter Stop Start...
- Page 41 Enter Start Enter Temper- ature Enter Enter...
- Page 42 ErrP FAIL...
- Page 54 Segment Rate Temperature Hold Rate Temperature Segment Hold...
- Page 55 The “120/208V” supply is increasingly en- needed—just spot-patch and sand off the countered in schools and newly-built com- surface evenly with coarse sandpaper munities, because it’s more efficient for wrapped around a wooden block. A fresh heavy 120V loads. This affects Models coat may be needed before a porcelain fir- KM-818, KM-1018, KM-1027 and KM-1227 ing if glaze has dripped onto the shelf.
- Page 56 Likely, everything will work as it should, and you’re ready to go on to production firings. If things go wrong, re-read this manual and contact your Skutt dealer. You will notice a clicking sound while your kiln is firing. This is normal. The ele-...
Need help?
Do you have a question about the KILNMASTER AUTOMATIC KILNS and is the answer not in the manual?
Questions and answers
What does r 7 mean on a 06 low fire medium mean?