Installation Requirements - LG LMC0975 Series Owner's Manual

us_main.book.book Page 8 Tuesday, June 8, 2021 11:55 AM
8 INSTALLATION
• Oven Cavity Dimensions (W x H x D): 12 11/16"
x 8 15/16" x 13 3/16" (32.2 x 22.8 x 33.5 cm)
• Capacity of Oven Cavity: 0.9 cu.ft. (0.02 m
LMC1575XX, MSWN1590L Model
• Power Supply: 120 V AC, 60 Hz
• Rated Power Consumption: 1250 W
• Microwave Output: Max. 1200 W
• Frequency: 2450 MHz
• Rated Current: 10.4 A
• Dimensions (W x H x D): 21 7/16" x 12 1/8" x 17"
(54.4 x 30.8 x 43.2 cm)
• Oven Cavity Dimensions (W x H x D): 15 9/16" x
10 5/16" x 16" (39.5 x 26.2 x 40.6 cm)
• Capacity of Oven Cavity: 1.5 cu.ft. (0.04 m
† IEC 60705 RATING STANDARD. Specifications
are subject to change without prior notice.

Installation Requirements

Installation Location
Place the microwave oven on a flat surface. Free
airflow around the oven is important. Allow at least
4 inches of clearance around the top, sides, and
back of the oven for proper ventilation.
• Do not place oven above a gas or electric range.
Electrical Requirements
The oven is designed to operate on a Standard 120
V/60 Hz household outlet. Be sure the circuit is at
least 15 A or 20 A and the microwave oven is the
only appliance on the circuit. It is not designed for
50 Hz or any circuit other than a 120 V/60 Hz
circuit. No other electrical appliances or lighting
circuits should be on this line. If in doubt, consult a
licensed electrician.
Voltage Warning
The voltage used at the wall socket must be the
same as specified on the oven name plate located
on the back or on the side of the control panel of
the oven. Using a higher voltage is dangerous and
may result in a fire or other type of accident
causing oven damage. Low voltage will cause slow
cooking. If the microwave oven does not perform
normally in spite of proper voltage, unplug and
reconnect the power cord.
Do Not Block Air Vents
All air vents should be kept clear during cooking. If
air vents are covered during oven operation the
3
)
oven may overheat. To prevent damage to the
oven, a sensitive safety device detects overheating
and automatically turns the oven off. The oven
cannot be used until it has cooled sufficiently.
†
Grounding Instructions
This appliance must be grounded. In the event of
an electrical short circuit, grounding reduces the
risk of electric shock by providing an escape wire
for the electric current. This appliance is equipped
with a cord having a grounding wire with a
grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded.
3
• Consult a qualified electrician or service person if
)
the grounding instructions are not completely
understood, or if doubt exists as to whether the
appliance is properly grounded.
- Use of an extension cord is not recommended.
If the power supply cord is too short, have a
qualified electrician or service person install an
outlet near the appliance.
- If it is necessary to use an extension cord, use
only a 3-wire extension cord that has a 3-blade
grounding plug, and a 3-slot socket that will
accept the plug on the appliance. The marked
rating of the extension cord must be equal to
or greater than the electrical rating of the
appliance.
• Ensure proper ground exists before use.
• Keep the electrical power cord dry and do not
pinch or crush it in any way.
WARNING
• Improper use of grounding can result in a risk of
electric shock.
NOTE
• A short power supply cord is provided to reduce
the risks resulting from becoming entangled in
or tripping over a longer cord.
• Longer cord sets or extension cords are available
and may be used if care is exercised in their use.