Westfalia Joker Maintenance And Operation page 17

To Lower the Bed:
If the back seats are equipped with head rests, these need to be
removed before building the bed.
To Build:
•
Loosen the seats by pulling Knob (A).
•
Pull the seats up slightly and forwards.
The back seat will then fall into the bed position. This will then
form the double bed.
To Return Seats to the Seating Position:
•
Pull the seats up by 90 degrees until they click into place.
•
Put the seats back, until they are secured into place.
Note: In the flooring of vehicles with a PVC Floor, there are tracks
to secure a middle seat. Where a middle seat is built in, the lower
double bed cannot be used.
Setting up the Double Bed in the Roof Area:
The roof area / loft must be set up as follows:
•
Pull the upper bed unit about 10 cm forward and fold down.
To Put Back
•
Fold the bed unit at the front down, and push back.
Double bed in the high roof vehicles
To assemble the bed into position:
•
Loosen Locks
•
Pull the bed extension forwards at the same time
•
Put in the middle cushion
To put the bed away, do the above steps in reverse.
Note: If there are no safety belts / secures for children, small
children should sleep in the lower beds.
Warning ! During the journey, no-one should occupy the
upper beds.
1.9 Tables
Table
•
Loosen the table by the dials (A) & (B)
•
Adjust the table to the required position
•
Secure using the dials (A) & (B)