Table of Contents
Advertisement
Available languages
Available languages
Disassemble the extension rod [1-14]
When disassemble the extension rod, pls must press the limited knob, then take out the extension rod.
1-14
OPERATE THE MACHINE
•
Do not control the machine's head.
•
Hold the machine with both hands.
•
Before operating the machine, make sure every fastening handle is closed.
•
Connect the machine to the main power supply.
•
Before switching on the machine, keep the sanding head slightly away from the work surface.
•
Start the machine for necessary sanding work.
•
Operate the machine with short length in narrow and awkward area.
•
Run the machine with medium length for higher walls.
•
Use the machine with longest length for ceilings.
•
Do not over-press machine so that to avoid overloading! Press with proper pressure for better grinding
effects. Good grinding effects and quality are mainly decided by choosing the right abrasive material.
•
Once finishing the sanding task, switch off the machine.
CARE AND MAINTENANCE
Remove the plug from the socket before carrying out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance. Always store your power tool in a dry place.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.
If a fault cannot be rectified, return the mixer to an authorized dealer for repair.
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
T: 00352/26908036 – F: 00352/26908040
L225-C
Advertisement
Table of Contents
