Albatros CIII 38” Albatros CIII Thank you for purchasing the Albatros CIII model for electric BUILDING THE MODEL flight. BEFORE STARTING THE MODEL A note about the photos: The photos were taken of a prototype and the parts supplied may look slightly different A semi scale adaptation of the Albatros CIII, this model is from them.
Albatros CIII 38” FUSELAGE CONSTRUCTION Adding The Undercarriage Plates The fuselage is built as two side structures, which are then joined over the plan. This system not only keeps each stage simple, but it also helps to ensure a straight fuselage.
Page 4
Albatros CIII 38” INSTALLING THE RADIO CONTROL GEAR Servo Bay It is as well to get the bulk of your R/C gear fitted at this stage, and also the motor. COVERING Any lightweight covering material can be used. Polyspan makes a good choice, Litespan is also popular. Robert Stinson used Solartex.
Albatros CIII 38” ASSEMBLY FLYING Robert posted this on Ezone's Scale Modelling discussion forum: Wing Using Spars And Aligning Wing Panels “The Albatros flew successfully today! You can now The first task is to epoxy the lower wings accurately onto the advertise the plane "as flown in the San Diego Mid-Winter...