Table of Contents
Advertisement
RELAY OUTPUT CARD, PCI
You must install the software before you set up the hardware.
4.1 Software
The Relay Output Card, PCI is a fully compliant PCI plug-and-play adapter. The
I/O address is automatically assigned by either your system or your plug-and-play
operating system.
For Windows users:
Choose "Install Software" at the beginning of the CD and select the digital I/O
software drivers.
4.2 Hardware
1. Turn off the PC's power. Disconnect the power cord.
2. Remove the PC case cover.
3. Locate an available PCI slot. Remove the screw and the blank metal slot cover.
4. Gently insert the card into the slot. Make sure that the card is seated properly.
5. Replace the screw.
6. Replace the cover.
7. Connect the power cord.
Installation is complete.
Once you install the card, refer to Table 3-1, which describes where in memory
each port is located. Use it along with Table 2-1 to define base addresses for the
input/output ports. See the examples in Section 2.5 for more information.
12
4. Installation
NOTE
Advertisement
Table of Contents
