Table of Contents
Advertisement
MINI DRIVER FOR MAC
The Mini Driver for Mac is easy to install. This
section tells you how to properly connect the Driver
to the twisted-pair interface and Mac phone port—
and how to operate the unit.
3.1 Connection to the Twisted-Pair Interface
The Driver supports data-only communication
between a Mac and another Mac serial device. There
are two requirements for installation:
1. These units work in pairs. You must have on
Driver at each end of a 4-wire telephone cable.
2. To function properly, the Driver's modular jacks
must be connected to two twisted pairs of metallic
wire. The pairs must be unconditioned, dry
metallic wire, between 19 and 26 AWG (higher
number gauges may limit distance). Do not use
standard dial-up telephone circuits or leased
circuits that run through signal-equalization
equipment.
For your convenience, the Driver comes with two
different twisted-pair interfaces—RJ-11 jack or RJ-45
jack.
8
3. Installation
Advertisement
Table of Contents
