Download Print this page

Geesa 6473 Assembly And Instruction Manual page 3

Advertisement

GB • Assembly and instruction manual•
1.
Safety Instructions
1.1 Main Voltage
Connect only to AC 220 - 240V
1.2 Caution
• Read this Assembly and instruction manual
before using the hairdryer
• Ensure that the voltage of the hairdryer is
identical to the main voltage
• When operating the hairdryer, safety distances
to baths, wash basins and showers should be
complied with
• Do not submerge the hairdryer in water and
do not clean the hairdryer wet or use with wet
hands
• Never use liquids or gas (hairspray) while the
hairdryer is switched on
• Because of overheating never cover the air
intake and air blow out
• People who are not used to the handling of a
hairdryer with wall holder (for example children)
must be instructed and informed about the
usage and possible danger. Children must not
operate the hairdryer without the supervision of
an adult
1.3 Overheating protection
In case of thermal overload the hairdryer will
switch off automatically. Release the Spring button,
turn the Main switch on the wall holder to "OFF"
and eliminate the cause of overheating. Once the
hairdryer has cooled down enough it is ready for
use again.
2.
Assembly
2.1 General Instructions
• Installation should only be carried out by a
qualified electrical expert, in order to comply
with the existing national safety regulations
• For additional protection, the installation of
a residual current device (RCD) with a rated
operating current not exceeding 30 mA is
recommended in the electrical circuit supplying
the bathroom.
• Before installing always switch off the general
switch of the main electricity
• When extended to the maximum lengths the
spiral cord of the hairdryer should not be
reached by a person using the bath or shower
3.
User Manual
When not in use the main switch on the wall holder
must be in the "OFF" position.
Main switch on wall holder:
Push-button on hairdryer:
(pressure must be maintained to operate the
hairdryer)
Switch on hairdryer:
C. Cool button
1. MIN (Low air speed, Low air temperature)
2. MAX (High air speed, High air temperature
4.
Maintenance tips
• The Main switch on the wall holder must be
switched to "OFF"
• Wipe the hairdryer and wall holder with a damp
cloth and clean the air intake with a vacuum
cleaner or a brush
• Defect hairdryers may only be repaired by
qualified electrical experts
5.
Recycling instructions
Old appliances contain valuable materials
that can be recycled. Do not dispose old
appliances with the normal domestic waste
but rather by way of appropriate collecting
points.
NL • Montage en gebruiksaanwijzing •
1.
Veiligheidsvoorschriften
1.1 Voltage
Sluit alleen aan op wisselstroom AC 220 - 240V
1.2 Waarschuwing
• Lees deze montage en gebruiksaanwijzing
nauwkeurig voordat u de haardroger in gebruik
neemt
• Controleer of het voltage van de haardroger
identiek is aan het voltage van de netaansluiting
• Hou bij gebruik van de haardroger rekening met
veiligheid afstanden tot het bad, de wasbak en
douche
• Hou de haardroger niet onderwater, maak de
haardroger niet nat schoon en gebruik de
haardroger niet met natte handen
• Gebruik geen vloeistoffen of gassen (haarspray)
zolang de haardroger aan staat
• In verband met oververhitting mogen de
luchtinlaat en de luchtuitlaat nooit afgedekt te
worden
• Mensen die niet gewend zijn aan het gebruik van
een haardroger dienen instructies te krijgen over
het gebruik en de mogelijke gevaren. Kinderen
mogen de haardroger niet gebruiken zonder
toezicht van een volwassene.
1.3 Bescherming tegen oververhitting
In het geval van thermische oververhitting zal de
haardroger automatisch uitschakelen. Laat de
drukknop los, zet de schakelaar op de wandhouder
op "OFF" en verwijder de oorzaak van de
oververhitting. Na afkoelen is de haardroger weer
ON/OFF
normaal te gebruiken.
ON/OFF

Advertisement

loading

This manual is also suitable for:

6475