Screen Replacement - Mitsubishi Electric WD-52531 Service Manual

CAUTION:
Lenticular Screen and Fresnel Lens Removal
1) Remove 28 screws (A) to remove the top, bottom and side HOLDER-SCREEN rails and their SPACERS from
the Screen Frame. (36 screws in the 62" model)
2) Lift the screens as a single
unit from the frame.
3) Separate the Lenticular Screen
and Fresnel Lens.
Note: When separating the Lenticular
Screen from the Fresnel Lens, use caution
while prying the Screen and Lens apart.
Use a slot type screw driver, and
remove the pressure sensitive double sided
tape.
Lenticular Screen and
Fresnel Lens Replacement
1) Apply LENS-TAPE along the rear top edge of the Lenticular Screen.
2) Place the Fresnel Lens on top of the Lenticular Screen, and apply pressure along the top edge.
3) Place the screens in the screen frame and reinstall the cushions, top, bottom and side rails.
NOTE: The Lenticular Screen label must face the front
and the Fresnel Lens label face the rear.
4) Reverse the Screen Removal Procedure and insert the
screens in the Bezel.
All manuals and user guides at all-guides.com
MODEL: WD-52531 / WD-62531 / WD-62530

Screen Replacement

Wear gloves when handling the Lenticular Screen and Fresnel Lens.
This prevents cuts and finger prints. Do not place Fresnel Lens in the sun.
This may cause fire and heat related injuries.
Page 14