Cleaning; Scales Cleaning; Specification; Trouble-Shooting Guide - Panasonic NI-GSE050 Operating Instructions Manual

CLEANING

Cleaning and Maintenance of the steamer head and power
base and the hose.
1 Unplug the power plug, wait until the steamer head,
steamer holder and power base have fully cooled down.
2 Wipe the surface of the nozzle
and the power base with a soft cloth.
For stubborn stains, use a soft cloth
dipped with neutral detergent to clean.
Remove the hose, clean up stains at
3
the hose interface and with the base
and the pole.

SCALES CLEANING

To maintain optimal steam performance, it is important to
remove scales and impurities inside the appliance regularly.
It is recommended to perform the easy rinse calc-clean process
at least once a month.
1 Unplug the power plug, wait until the steamer head,
steamer holder and power base have fully cooled down.
2 Remove the telescopic pole, hose, and water tank from
the power base.
3 Pour the water in power base out from the hose hole (as
shown in the figure).
Place the power base on a horizontal
4
place, install the water tank containing
water on the power base, leave them for
about 10 seconds, and then
remove the water tank. Hose hole
Pour the water in power base
5
out from the hose hole (as shown
in the figure).
12

SPECIFICATION

Model NI-GSE050 NI-GSE040
Vietnam 220 V 50-60 Hz
Rated
UAE/Kuwait
voltage
220-240 V 50-60 Hz
/Oman/Saudi
Vietnam
1 800 W 1 600 W
Power
UAE/Kuwait
1 500-1 800 W 1 345-1 600 W
/Oman/Saudi
Weight Approx. 3.2 kg
Steam selector 2-Level steam
Dimensions (assembly) (WxDxH) Approx. 24 x 24 x 166 cm
Single-phase three core plug /
Plug / Cord length
Approx. 1.5 m
Corded steam hose
Approx. 1.2 m
length
Water tank capacity Approx. 2 L
Thermostat system Temperature fuse
This product is intended for household use only.

TROUBLE-SHOOTING GUIDE

Problem Causes
The power plug has not been plugged in or the
power button has not been pressed down.
Condensate water that produced from steam
The product
remains in the hose.
produces no steam
or irregular steam.
The water tank is empty or less than
" " line.
The water tank and hose is not be installed
correctly to the power base.
The cap is loose.
Water leaks out
from the power
base
The hose is bend.
The telescopic
pole slips down The garment on the hook is too heavy.
unexpectedly
The product
produces a The hose forms a U-shape.
water noise.
If you can not solve your problem according to the above solutions.
Have your product repaired by the specified service agent.
Solution
Insert the power plug and be sure to press
the power button.
Lift up the steamer head vertically and straighten
the hose，to make condensate water backflow.
Fill the water tank with water.
Attach the water tank and hose to the power
base correctly.
Close the cap correctly .
Straighten the hose.
Lighten the weight loaded to the fixing hook
(less than 2 kg).
Do not bend the hose.
13