Except as otherwise expressly provided in writing, AAF makes no representation or warranty in connection with explosion hazard equipment, including, but not limited to, the necessity or effectiveness of explosion hazard equipment or to the design, installation, operation, and performance of such equipment.
Page 7
For instance, if an explosion suppression system is being supplied by parties other than AAF, it is incumbent on the user to ensure that the dust collection equipment has been ordered to resist the internal pressure defined by the suppression equipment supplier.
2.4 Electrical hazards Before doing any work on the AAF equipment make sure that all potential electrical hazards have been identified and that all electric current connected to the equipment, and to any connected or associated equipment, has been properly disconnected and securely locked-out to prevent accidental reconnection prior to completion of the work.
AAF ArrestAll. 5.3 Inspection on arrival The AAF ArrestAll is normally shipped by truck and should be checked for damage that may have occurred in route. Compare the collector(s) received to the description and/or drawing of the collector(s) ordered. Immediately report any differences or missing items from the order to AAF International.
Contact AAF International for claim filing procedure. 5.5 Missing goods Any missing goods should be noted on the delivery receipt, and the carrier and AAF notified immediately. Contact AAF International for claim filing procedure. UNLOADING AND HANDLING 6.1 Unloading Failure to lift the collector correctly can result in severe personal injury, property damage, or even death.
9.1 Introduction Safe and efficient operation of the ArrestAll depends on proper installation. AAF recommends that the ductwork going into the collector be as straight as possible, with at least 5 diameters of straight run recommended. Authorities with jurisdiction should be consulted before installing the ArrestAll to ensure local installation laws, codes, regulations and procedures are followed.
Refer to the installation drawing for additional information. There are two filters that can be used- HEPA rated and 95% ASHRAE filters. Contact AAF International for assistance in filter application. 9.2.5.2 Hopper Discharge Devices Funnel bottom units come standard with a barrel top adapter. The barrel top adapters are field installed on the bottom of the funnel bottom (Figure 8).
Three to four duct diameters of straight run will give an even airflow distribution at the inlet. EXPLOSION VENTS The following only applies to AAF-supplied explosion vents. Additional and/or different steps, equipment, etc. may be needed for vents and other equipment not supplied AAF.
The following is a list of recommended AR ArrestAll replacement parts. For multiple collector systems, the quantities of each spare part should be adjusted accordingly. If needing equipment other than what is listed, please call AAF International or your local AAF Representative with a control number and/or serial number.
Page 32
AAF Hava Filtreleri ve Ticaret AS Email: redfiltration@aafintl.com Hürriyet Mahallesi Daikin Australia Pty Ltd Yakac1k D-100 Kuzey Yan Yol No: 49/1-2 (AAF Australia & New Zealand Sales Office) AAF, S.A. 34876 Kartal, Istanbul, Turkey 15 Nyadale Road Scoresby Victoria 3179, C/ Urartea, 11...