AGPtek CN16G Manual

SKU: CN16G
Electric Nail Drill Pen 6 Bits

Features

Light-weight design for precise operation
Suitable for Professional salon, Studio or Home Use
Suitable for pedicure and manicure
Quiet and Smooth
Portable & Easy to carry out
Multi use: carving, engraving, routing, grinding, sharpening, sanding, polishing, drilling
and so on
The nail file can be used for natural nails as well as artificial nails

Specification:

Power: single phase, 110V/60Hz, double insulated
PRM: 3000-13000
Collet type: 2.4mm
Color: Pink.

Operation

1.This tool is design for carver, engrave, rout, grind, and sharpen, sand, polish, drill and
more.
2. Unplug the tool from electrical outlet before loading a bit.
3. Press shaft lock button, rotate the collet nut anticlockwise (but do not take the nut
out)， insert the bit, press shaft lock button and tighten the collet clockwise securely. But
avoid excess tightening of the collet nut in case of damage in the nut.
4. Slide the on/off switch to find the speed needed between 3000-13,000RPM. Slide the
switch to the black dot for complete stop.
5. When finished, unplug the tool, take the bit out and store the set in dry place.

Safety Rules:

1. Always unplug the tool when you change accessory/collet or finish using the machine.
2. Do not engage the shaft lock button while the tool is running.
3. Never use a damaged bit.
4. The machine is not waterproof. Please keep away from water. If the machine falls into
water, unplug it immediately and do not touch the water.