Accessories Description Part no. Grease pump M-08, manual 59800 Including 2 of Grease cartridges. 49811 Grease cartridges can be ordered separately. We strongly recommend Blasolube 301. Please see section Technical Specification - Pressurizing medium. Spare parts list Position Description Part no. Hydraulic connector 49828 High pressure hose...
Table of Content Accessories Spare Parts List Exploded view drawing Table of Content Safety Warning Proper Use Operator’s Obligations Basic Safety Instructions Safety- and Danger Symbols Safety Instructions for the Use of the Product Maintenance, Service and Troubleshooting Warranty and Liability Designations of the components shown (Figure A–B) Assembly/ Installation Directions for use...
Safety Warning Read this Operating manual through carefully in order to familiarise yourself with the safe and efficient operation of this product. keep this manual for reference purposes. This Operating manual contains important instructions and directives for the safe and proper operation of the product. It should also help operating and maintenance personnel to minimise dangers, repair costs and down times and increase the reliability and operational life of the product.
Designations of the components shown (Figure A-B) 1. Hydraulic connector 7. Piston rod 2. High-pressure hose 8. Handle 3. Air release valve 9. Front cover cap 4. Cylinder 10. Cartridge 5. Actuating lever 11. Rear cover cap 6. Locking notch...
Operating instructions Connecting 1. Place hydraulic-connector at end of hose on the high pressure valve. Ensure that the valve is free of impurities! 2. Close the air release screw. Applying pressure 3. Actuate lever until gauge indicates pre-selected pressure. Disconnecting 4.
Packing, Transport and Storage The product will be prepared for transport to its first destination by ETP. The packing unit may not be subjected to any excess load. The packaging and its content must be protected from moisture. The transport temperature must be kept between –...
This Operating manual is a component of the product and belongs in the scope of delivery in the event of re-sale. ETP HYDRO-GRIP High pressure pump M-08 Supplier: Manufacturer: ETP Transmission AB Abnox AG Box 1120 Langackerstrasse 25 SE-581 11 Linköping CH-6330 CHAM...
Page 16
E 463-2 Box 1120, SE-581 11, Linköping, Sweden Phone: +46 (0)13 24 71 00 E-mail: info@etp.se, Internet: www.etp.se...
Need help?
Do you have a question about the HYDRO-GRIP M-08 and is the answer not in the manual?
Questions and answers